Description
A high-quality compressor designed specifically for bass.
Like the previous model, the controls typically only found on high-end studio equipment allow for detailed settings, helping you create a professional sound. Add rich character with a fully controllable sidechain high-pass filter and two-position Tone + Color switch.
The fact is that conventional pedal compressors often produce lackluster sounds in exchange for controlling dynamics. The Bass Compressor gives you great control over musical expression and delicate touches to perfectly shape your sound. This is definitely a must-have for all bassists.
■Full control and LED meter similar to a studio compressor.
Equipped with all the same controls as rack-mounted equipment in a recording studio. Opens the door to new sound creation for bassists. Input/Ratio/Attack/Release/Output can be controlled individually, allowing you to pursue the optimal compression for any song. From transparent compression similar to a studio compressor to deep limiting sounds, you get the best sound and control in pedal format.
In addition, it is equipped with a highly visible LED meter that has never been installed on a pedal type compressor! This excellent meter can monitor both gain reduction and input level at the same time, allowing you to visually check the GROOVE of your music while shaping your sound.
Empress Effects' Bass Compressor has bass-specific features such as extended bass frequency response (10Hz to 20kHz@-3dB), a fully variable side-chain high-pass filter, and a Tone+Colour switch tuned for bass instruments. I am.
It is the only bass compressor that can perfectly handle all levels required by professional bassists.
■Equipped with mix control for original sound and effect sound!
Bass Compressor allows you to use a guitar pedal to implement the "parallel compression" technique used in studio recording.
Normally, the output of a compressor pedal is 100% of the effect sound, but with this unit equipped with a "Mix controller" as standard, you can freely control the ratio of dry/wet signals. If you use only the compressed effect sound (wet), the sound will inevitably sound congested, but by adding a little bit of the original sound (dry), the sound will become surprisingly lively. With just one pedal, you can achieve an organic compression effect that maintains complete control over dynamics and sustain without losing any of the original sound.
■Side chain high pass filter and advanced settings.
Bass Compressor adds a fully variable “sidechain high-pass filter”.
For even more precise bass control, the SC HP knob allows him to continuously vary the filter frequency from 20Hz to 400Hz.
By cutting the low frequencies of the signal sent to the gain reduction detector, you can prevent the compression from overreacting to the bass band. By utilizing this studio technique, you will be able to obtain optimal compression effects, especially for bass instruments.
Additionally, the top of this unit is equipped with a TRS terminal that allows you to connect external devices to the side chain circuit, allowing side chain control from an external EQ unit, etc. You can also use equalization to emphasize specific bands, making the compression response particularly strong for peaky parts such as picking. It allows you to create a professional sound with more control over harsh sounds.
In addition, in the advanced settings, you can set whether to start up with effect bypass or effect on when the power is turned on. This is a very useful feature if you want to use the compressor in an always-on state.
■Tone + Color switch
Bass Compressor has added a special “Tone + Color Switch” specifically for the bass band.
Push the switch to the left for "midrange (500Hz) cut," and push it to the right for "upper midrange (2kHz) boost."
At the same time, by passing it through a color circuit, you can add a slight overtone texture to the sound. By adding harmonic components, you can enjoy a distinctive bass sound with a strong presence. The color circuit can also be turned on or off in two positions using an internal DIP switch. Turning off the color circuit enables only pure equalizing operation, keeping the sound clear when the tone + color switch is enabled.
■Differences between Compressor MKII and Bass Compressor
●MKII's side chain high pass filter has two frequency options to choose from, while Bass can be freely set between 20Hz - 400Hz with a knob. A side-chain high-pass filter is particularly effective for instruments that have a lot of low-frequency information, such as bass, because it smooths out the high-end that pops out, but at the same time doesn't completely crush the low-end. Fully configurable knobs allow for more precise filter control. Although high-pass filters are not that important in guitars, the MKII also has filter options that allow you to create a wide range of sounds.
●In contrast to the MKII's Tone knob, Bass is equipped with a "Tone + Color" switch, and provides two preset EQ curves optimized for the character of the bass. One is a mid-scoop centered at 300Hz that slightly boosts the low range, and the other is a mid-boost centered at 2kHz. Boost makes the string resonance and pick attack stand out and makes it more aggressive, while Scoop removes muddiness and creates a warmer, more pleasant tone. The Color circuit is activated when you turn on one of the EQ curves. This circuit consists of mild clipping and adds slight harmonic distortion. There's also a slight volume boost and filtering added to make it the perfect match for bass. It's actually great in combination with guitar, but I wanted to make something special for bass! An internal DIP switch allows you to turn off the Color circuit independently of the EQ shape.
●Bass Compressor has expanded response to low frequency bands. Especially when using light compression with the Input knob set low, you'll feel a rich low end.
■SPECIFICATION
Input Impedance: 1MΩ
Output Impedance: 2.2kΩ
Frequency Response: 10Hz – 20kHz (-3dB)
Distortion:＜0.1%
Noise: –101dB
Headroom: +15dBu
Attack：50μsec – 50msec
Ratio: 2:1, 4:1, 10:1
Release: 50msec – 1sec
Sidechain HPF: 20Hz – 400Hz (variable control)
Power: 9VDC (TIP = -), 100mA
Size: H64mm × D122mm × W66mm
Weight: 454g
*The image is a sample.
◆Condition: S: New
◆Accessories: Box
Payment
Please pay within 4 days after purchase.
Shipping
Please refer to Shipping and handling.
About other area, please ask me.
Returns
Returns are accepted ONLY if the item was not the item described.
International Buyers - Please Note:
* Import duties, taxes and charges are not included in the item price or shipping charges. These charges are the buyer's responsibility.
* Please check with your country's customs office to determine what these additional costs will be prior to bidding/buying.
* These charges are normally collected by the delivering freight (shipping) company or when you pick the item up - do not confuse them for additional shipping charges.