Hey folks, I make these by hand in my small lab located on the east coast of Canada.

It’s perfect to plug your guitar or bass into before a recording interface to warm up your tone. The circuit is very similar to many popular amps and should sound and feel right at home as soon as you plug in. With only the volume control, clean to a wide range of overdrive sounds can be created. The output level is suitable for guitar amps, pedals, audio recording interfaces, and mixers. Most devices with an instrument or line level input.

The output is capable is a hot signal so be careful and start with the volume low before cranking it up.

Simple audio path consisting of a single 12AX7 tube and as few components as possible needed to make it sound great, and be reliable and affordable.

Features:

1/4” Switchcraft in and out jacks

Belton tube socket

Hammond 290x power transformer

12AX7 tube

Alpha volume pot

Custom wood/copper turret board

1a fuse

3 prong power jack, cable included.

100% analog signal path

These are made one at a time and thoroughly tested in the lab. I’m self taught with electronics but have over 20 years of experience and take pride in my workmanship. If you ever have any questions, comments or considerations don’t hesitate to reach out and let me know. That being said, this is a handmade high voltage device that can be dangerous if not used with caution, so please keep that in mind if considering a purchase.

The device you will receive when purchasing will not be the one pictured, the one pictured is my prototype model and I would like to keep it for myself. You will receive one just like the one pictured though, except for minor differences due to the handmade nature of the preamp.

These are made to order and the ship date is approximately 2 weeks after purchase is completed.

I take no responsibility for any damage incurred by the use of this device. These do not have any electrical safety certification.

Thank You for looking!