Wheel Nut FOR Daihatsu  Models Listed in The Compatibility Table

FREE CARRIAGE ORDER AS MANY AS YOU NEED

Important Note ( please check ) :

ONLY SUITABLE FOR WHEELS THAT REQUIRY A TAPERED 60 DEGREE SEAT, WILL NOT SUIT WHEELS THAT REQUIRY A

FLAT WASHER SEAT.

Wheel Nut Specifications

Steel Strength : 10.9

Overall Length : 35MM

Thread Size : M12 x 1.5

Bolt finish: Bright zinc plated

Seat type: Tapered (Cone shaped) 60 Degree

Hex Head Size : 21MM

You can check your Bolt Head Size Using a 21mm Socket, These Nuts are 21MM hex Head.

Every effort has been made to ensure the accuracy of these fitment details. However , due to the wide variety of original and aftermarket wheels available, WLW Ltd cannot guarantee or be held responsible for all applications.

WLW Ltd strongly recommends that each installation should be inspected during fitment and thoroughly checked after fitment (by spinning the wheel if necessary) and after 200 miles (300km) use. Torque settings should be in accordance with the vehicle manufacturer's recommendations, if you are unsure about any aspect of fitment, do not attempt to fit but contact your us via Email.

Warning

Your wheel hubs or brakes may be adversely affected by wrongly fitted wheel nuts, bolts or locks. Do not use air guns to fit.