SWAG Off Road Dimple Die Set (8) Pieces
(1/2", 3/4", 1", 1-1/4", 1-1/2", 1-3/4", 2", 2-1/2")
Whether it
be for cosmetic applications or looking to improve the rigidity of
plate steel the SWAG dimple dies are capable of dimpling 3/16" steel.
Made
in the USA out of domestic steel these dimple dies come with a life
time warranty, you split them in half and we will replace them free of
charge, it's that simple. These dimple dies are CNC machined out of
4140 quenched and tempered chrome moly steel that has a tensile strength
of 150,000 KSI. Each dimple die has a through hole drilled into both
the male and female dies so they can be used in a few different ways.
The
first method is they can be used in any H frame hydraulic press where
the material you are dimpling is small enough to fit between the
vertical frame rails of the press. Simply drill the appropriate size
hole using an industry stand hole saw, then insert the male and female
dies to the correct orientation then using the hydraulic cylinder, press
the dimple dies down to flare the metal.
The second method is
they can be bolted together using a standard off the shelf grade 8
fasteners 3/4" dia bolt or 7/16" dia bolt depending upon which dimple
die size you have. This method is ideal for large pieces of metal that
are too large to fit in a H frame style press, dimpling on a vehicle or
dimpling after the fact....."Hey we should have put a dimple die
there"...Well now you can with the through hole design that is standard
on every die set we produce.
The
third method is they can be pressed together using a 10 Ton Hydraulic
Knockout Punch Driver as shown in the picture above. Not sure what one
is, check out Ebay or Harbor Freight, they sell for ~ $100.00 shipped to
your door step and they are a real time saver if you are dimpling a
large number of items or hard to reach dimple die locations, it included
a manual hand pump to apply hydraulic pressure to the punch set. The
knock out punch set is a quality product as we have dimpled thousands
of holes for years using this set up. We even attached a Harbor freight
foot operated air/hydraulic foot pump Central Hydraulics - item #98318 for even faster semi-production speed dimpling.
Are
looking to dimple dies holes that are close together but not have them
overlap, if so you you need to position them so the outside diameter
will not interfere with the other dimple died holes.
The over all outside diameter of the dimple dies are as follows;
.500" dimple die OD = 1.20"
.750" dimple die OD = 1.45"
1.00" dimple die OD = 1.95"
1.25" dimple die OD = 2.40"
1.50" dimple die OD = 2.70"
1.75" dimple die OD = 3.17"
2.00" dimple die OD = 3.40"
2.50" dimple die OD = 4.20"
The HF Knock Out Punch part number is #96718
The HF 10,000 PSI Air Hydraulic Pump part number is #98318
Please
Note: We do not sell the knock out punch set or Air/Hydraulic foot
switches, they are shown in the image gallery for reference only. At
this time we are not going to split up our dimple die sizes and sell
them individually.
This item ships out using USPS priority mail, please provide a valid USPS shipping address.
Additional details can be found on
our website: swagoffroad.com