NOTE -- This is a DIY type of KIT... It will NOT magically apply itself to your board. You are responsible

for the creativeness that it takes to fasten it to your board and power it up.

You can use any style battery source 9-12v DC to power your lights (a standard 9v battery will work) or any other DC battery source.

The light strips come with 3M pre applied tape for easy application on a SMOOTH, CLEAN, DRY surface. This tape will hold the lights

in place while you complete you install. If this tape does not stick to your particular board then you must use another form of adhesion, such

as contact cement, gorilla glue etc. (one again it is YOUR responsibility to make sure the lights are attached to your board)

This kit comes with FULLY Submersible 16ft LED's (300 lights total)

Colors Available:

COLORS Available:

Blue

Red

Green

Please leave a message about what color you would like.....