1. |
Scope |
This specification applies electret condenser microphone (E.C.M) |
2. |
Model No. |
M7WP-MIC |
3. |
Operation Condition |
|
3.1 Temperature |
-20~+70℃ |
|
3.2 Relative Humidity |
35%~85%RH |
|
3.3 Pressure |
86~106Kpa |
|
3.4 Environmental Noise |
36dB (Maximum) |
|
3.5 Operation Voltage |
1~10VDC |
|
3.6 Earth |
⊙ |
|
4. |
Electrical Characteristics |
|
4.1 Standard Operation Voltage |
3VDC |
|
4.2 Impedance |
2.2kΩ (Maximum) |
|
4.3 Current Consumption |
0.5mA (Maximum) |
|
4.4 Sensitivity |
-29dB±2dB(0dB=1V/Pa,1KHz) |
|
4.5 Directivity |
Omni-directional |
|
4.6 S/N Ratio |
40dB(Minimum) |
|
|
4.7 Schematic Diagram |
|
4.8 Test Temperature |
20℃±2℃ |
|
4.9 Frequency Response |
||
5. |
Mechanical Characteristics |
|
5.1 Dimension |
¢6.0±0.1×5.0±0.2 |
|
5.2 Mass |
≦0.35g |
|
5.3 Dimensional Drawing |
||
6. |
Reliability Tests |
|
6.1 Vibration |
Frequency1 10Hz~55Hz |
|
6.2 Shocks |
Pulse Shape Half Sinusoidal |
|
6.3 Dry Heat/Cold |
70℃ for 72hrs -20℃ for 72hrs |
|
6.4 Damp Heat |
90%RH,+40℃ for 120hrs |
|
Temperature Cycles |
-20℃←→25℃←→70℃ |
|
7. |
Cautions |
|
7.1 The soldering copper of a smaller type of less than 20W shall be applied. |
||
7.2 The temperaure of the working surface of the soldering copper shall be below 270℃. |
||
7.3 E.C.M shall be solderde fixed on the metal block (heat sink)which has the higher |
||
7.4 The soldering time for each terminal shall be 1~2 sec. |
||
7.5 The pin hole soldering shall be avoided. |
||
7.6 E.C.M may easily destroyed by the static electricity,and the countermeasure for eliminating. The staticelectricity (the ground for soldering copper,f or worktable and for human body) shall be executed. |
Excellent microscopic