The "OFFi" switch is the latest offering from the designer of the popular "Stiffi" Anet A8 X-Axis Brace. (Thingiverse 1985444)

This switch can act as a normal on/switch, or it can be easily flipped into auto-off mode. When activated in auto-off mode, your printer will automatically shutdown when your print finishes. No gcode changes required!

Save Energy. Save wear and tear on power-supply, fans, and main board. Now you can start that long print, and not worry about getting back in time to shut down the printer.

Comes fully assembled, 3d printed in PLA plastic. Switch and wiring rated at 240vac 15a. Installation and wiring instructions included.

Colors may vary. Design subject to improvement without notice.

Compatibility Notes:
- This switch is intended for Anet A8 model printers only.
- Verify your printer frame has a 20mm hole in the rear, just under the bed and to the left of the bed connector.
- Verify that the top edge of the hole is approx. 15mm from the top edge of the frame.
- Verify nothing is going through the hole.
- Verify that when your bed is fully retracted and pressing the Y limit switch that it extends over the rear edge of the frame between 22mm and 26mm.

The seller cannot assume any responsibility for damage caused by miswiring or misadjustment of this device.