PLEASE READ ENTIRE AUCTION CAREFULLY BEFORE PURCHASING.
 
Important:  We will now be EMAILING installation instructions upon purchase of kit.
 
Volvo TPS Assembly Kit FOR SALE!
As of 3/22/17 we have sold 249 of these kits, due to a glitch with eBay we had to relist the item and that reset the quantity sold to zero.

IMPORTANT:  Please VERIFY that your module is the same as the one in the auction photos before ordering. 
Your vehicle MAY have a different module.
 
If you have ANY questions, please make sure you ask before purchasing as there are NO refunds for this kit once it has been installed.

This auction applies to the following vehicles - Please VERIFY that your module is the same as the one in the auction photo before purchasing:
  • 1999 - 2002 Volvo C70
  • 2001 - 2002 Volvo S60
  • 1999 - 2000 Volvo S70
  • 1999 - 2002 Volvo S80
  • 1999 - 2002 Volvo V70
  • Other years and models may apply.
  • Please VERIFY that your module is the same as the one shown in the auction photo before purchasing.
This auction also applies to the following parts #'s:
  • 8644344
  • 8644345
  • 8644346
  • 8644347
  • If the throttle body from your vehicle looks like the one in the auction photos, this kit should work.
Important information regarding this auction:

This NEW sensor is contact-less and will not become worn over time as there is no contact between parts.  The original sensors have a carbon resistor potentiometer strip that can become worn through as the wiper moves across it.  If your original throttle body has a worn throttle sensor strip, then this kit should fix your problem.  Keep in mind that the ETM can have other problems, so there is no guarantee this will restore your ETM if you have a good or bad throttle sensor strip.

If you are using your original ETM and it is in good working order then there is no need to update (ETM RELOAD) after the newly rebuilt throttle body is re-installed.

This kit should correct the following:
  • Rough or surging idle
  • A dirty throttle plate can stick, which will also cause a rough/surging idle.  We recommend cleaning the throttle plate before purchasing or installing this kit as that may clear the rough/surging idle issue.

Please contact us through eBay if you have ANY questions about this kit.

You will need the following tools to properly install the new sensor:

  • T20 Torx Bit
  • Flat head screw driver
  • Dremel tool with cutting disc
  • 10mm socket and wrench
  • Loctite (red is best)
  • Box knife
  • Soldering iron
  • Solder
  • Permatex Ultra Blue Silicone - Recommended as other types will deteriorate solder over time
  • Electricians tape
  • Clamp for lid (if needed)
Optional but RECOMMENDED:
  1. Eye protection
  2. Respirator or mask
  3. Gloves
  4. Vise - Very handy to hold module in place while working

When you purchase this kit you will receive the following:

  • NEW digital sensor and matched magnet
  • NEW replacement silver lid
  • NEW premium Fel-Pro gasket
  • NEW wire clamp
  • NEW wire loop tube (gray)
  • We will email you the installation instructions
  • Soldering tools and skills are necessary

VERY IMPORTANT!  Please read the following:

It is VERY important that your ETM truly has a worn sensor to ensure the success of this kit.

There is a somewhat simple test you can do to check the old sensor for wear marks but this will destroy the sensor in the process:

  • Remove the old sensor (see last auction photo showing which side is the sensor)
  • Pull the old carbon strip out and hold it to the light (please see auction photo provided for an idea of what you're looking for)
    • If you CAN see light through the black part of the strip then this kit should fix your problem.
    • If you CAN'T see light through the black part of the strip then you may have a bad ETM (internal computer fault) and this kit may not fix your problem.

Please contact us through eBay if you have ANY questions about this kit.

  • If you contact us with questions please keep in mind that our business hours are 8am - 4pm Pacific Time Monday through Thursday and we are closed on the weekends and all major holidays (these are subject to change):

    • Memorial Day
    • July 4th
    • Labor Day
    • Thanksgiving (Thursday and Friday)
    • Christmas - New Years Day (12/25-1/1)

Important:  We will now be EMAILING installation instructions upon purchase of kit.

If you have ANY questions, please make sure you ask before purchasing as there are NO refunds for this kit once it has been installed.