Press brake kit comes unassembled, you do the final assembly and welding.

You asked for it ..........& here it is.  

Constructed out of high strength 3/8" steel with a 1.0" x 4.0" thick top die and 3.0" wide  bottom die.

This 50" press brake kit will bend steel up to 49" wide and is designed to fit in hydraulic presses that are at least 52" wide between the vertical beams, however it kit can easily be cut down or modified to accommodate smaller presses.

Note, the max bending width and thicknesses are determined upon your hydraulic press and thus actual numbers are dependent upon your press. But with ample tonnage and proper support, this brake will bend up to 1/4" of A-36 steel full width. We recommend 60 tons; (3) 20 ton jacks spaced evenly works great.

Tools required for assembly, welder, grinder, level, small square.

Check out the first link below for a fully detailed list of material needed to create your own I beam press brake stand...which is less work than your probably thinking & fairly inexpensive, considering what it allows you to create.