Additional Information

Listing Includes:

> Width: 75 mm (3") Material: Uncured EPDM Rubber

   Order Amount: Per Linear Metre.

Installation Notes: Ensure your two pieces of EPDM membrane that you wish to join are overlapping by 75 mm (3"). Fold back the top layer and apply rubber primer to both surfaces. Wait until the primer is dry to the touch and then, leaving the backing film on the splice tape starting at one end stick the tape down onto the bottom EPDM membrane.

Use your hand to smooth down the splice tape ensuring there are no creases. allow the top membrane to fold back into position and then peal away the backing film pulling at a 45 degree angle while smoothing the top membrane over the seam tape with your hand.

Bonding to other surfaces: The seam tape can be used to join the EPDM rubber membrane on to both TPO and PVC roofing systems. The tapes are often used to repair damaged TPO and PVC as a cost effective alternative to replacing the whole flat roof. When joining the rubber membrane to uneven or granular built up roof surfaces such felt or Asphalt we recommend the use of a Termination bar and water cut off mastic (water block)