*Buyer must have unloaded equipment (i.e. forklift) available at the delivery location, or you may pick up at the local Fedex freight terminal. If buyer is not capable of unloading, we will cancel the order.*Plz leave a contactable phone no. for delivery confirm

Auto Car Lift L1000

Warranty:

• 12 months warranty ! When you choose us, you will get the BEST warranty on eBay.
• Most of the sellers don't provide or only provide warranty for those parts for 3 or 6 months, 1 year at most. Please compare with others before you make the decision. Get into our shop and you will see the details of terms and conditions, especially the best warranty!

Auto Car Lift  L 1000

Features   220V  60HZ  1PH   3HP MOTOR

Safety Mechanism:

.come with adjustable pads and truck adapters
•Double Point Safety Lock Release
•Automatic arm lock restraints
•Relief valve built in power pump to prevent overloading
•Door guards protection rubber
•Heavy duty 5/16" diameter cable and 4.56" pulley reduce high stress on synchronization process and increase cable life
•Stiffened base plate 5/8" thickness
•Ultra high molecular self lubricating nylon slider ensures carriage smooth moving up and down
•Anchor bolts/mounting hardware included
 
Control System
•Lifting operation by pressing "UP" button on motor
•Manual lowering operation by pressing lever
•Relief valve built in power pump to prevent overloading
•1 sets truck adapters included
•Lifting Capacity: 10,000 lbs
•The overall Height  111-1/4"
•The overall Width  133-1/4"
•Column Width    10.62"
•Base Width   18.89"
•Column Thickness of Steel    3/16"
•Carriage Thickness of Steel   15/64"
•Arms Thickness of Steel     15/64"
•Front Arm    30.7" to 48"
•Rear Arm     30.7" to 48"
•Min pad height: 3-7/8"
•Lift height max: 71"
•Drive-thru width clearance: 99.2"
•Time to full rise: 20-60 sec
•Shipping Weight: 1311 lbs

 Site Selection

Before installing your auto lift, check the following:
• Lift Location: Always use architect’s plans when available.  Check layout dimension against floor plan requirements making sure adequate space is available.  Your lift
requires a 220v, 30amp, single phase, grounded electrical source.  There should be room enough to operate the lift in a safe manner and without restrictions.
• Overhead Area: The area where the lift will be located should be free of overhead obstructions such as heaters, building supports, electrical lines, doors, lights, etc.
• Floor Area: Visually inspect the site where the lift is to be installed and check for cracked or defective concrete.

Floor Requirements
• A level floor is suggested for proper installation and level lifting.  Small differences in floor slopes may be compensated for by proper shimming.  If a floor is of questionable slope, consider a survey of the site and/or the possibility of pouring a new level concrete slab.
• New concrete must be adequately cured for at least 30 days.

DO NOT install auto lift on any asphalt surface or any surface other than concrete.
DO NOT install auto lift on expansion seams or on cracked or defective concrete.
DO NOT install auto lift on a second/elevated floor without first consulting building architect.
DO NOT install auto lift outdoors unless special consideration has been made to protect the power unit from inclement weather conditions.

Concrete Specifications

2-post lifts (under 12,000 LB. capacity):

Four (4) inches of concrete at 3000 PSI

12,000 pound two-post lifts (and higher capacity):

Six (6) inches of concrete at 3000 PSI is required.

We do not ship to Alaska, Hawaii, Puerto Rico, PO Boxes, or APO/FPO addresses.