*Buyer must have unload equipment (i.e. forklift) available at delivery location, or you can pick up at local Fedex freight terminal.
installation video: https://www.youtube.com/watch?v=SrWsViQW_eY&t=25shttps://www.youtube.com/watch?v=SrWsViQW_eY&t=25s
Warranty:
•Time to full rise: 45-60 sec
•Shipping Weight: 1100 lbsSite Selection
Before installing your auto lift, check the following:
• Lift Location: Always use architect’s plans when available. Check layout dimension against floor plan requirements making sure adequate space is available. Your lift
requires a 220v, single phase, grounded electrical source. There should be room enough to operate the lift in a safe manner and without restrictions.
• Overhead Area: The area where the lift will be located should be free of overhead obstructions such as heaters, building supports, electrical lines, doors, lights, etc.
• Floor Area: Visually inspect the site where the lift is to be installed and check for cracked or defective concrete.
Floor Requirements
• A level floor is suggested for proper installation and level lifting. Small differences in floor slopes may be compensated for by proper shimming. If a floor is of questionable slope, consider a survey of the site and/or the possibility of pouring a new level concrete slab.
• New concrete must be adequately cured for at least 30 days.
DO NOT install auto lift on any asphalt surface or any surface other than concrete.
DO NOT install auto lift on expansion seams or on cracked or defective concrete.
DO NOT install auto lift on a second/elevated floor without first consulting building architect.
DO NOT install auto lift outdoors unless special consideration has been made to protect the power unit from inclement weather conditions.
Concrete Specifications:
2-post lifts (under 12,000 LB. capacity):
6 inches of concrete at 3000 PSI recommended by manufacture.