For sale: **MOD ONLY THAT FITS**  The Inspire1 and the Inspire1 v2. With the large 2.4Ghz antenna you will get Longer Distance with Antenna Mod. This Kit will Improve The receiver  to your Transmitter and Get More Distance with it.The Circular polarized antenna's aka "clover leaf antennas for SUPER LONG RANGE BOOSTER.


Circular polarized antenna's aka "clover leaf antenna. This antenna is a great way of increasing range for FPV with a solid signal link without boosting the output power. Customers have reported extending the range by 3 - 4 times traveling up to 6+ miles compared to a 2db dipole antenna.

This high gain antenna could be used to transmit from the TX to the plane or multicopter. It could also be used as a high gain video receiver antenna on the 2.4ghz band.


This is best when used as a stand alone antenna (specifically designed for FPV 2.4ghz Frequency).

COMES WITH RG402 SEMI RIGID CABLE.

This antenna is for outdoor/indoor use.

This Circular polarized antenna's aka "clover leaf antennas is specifically made to be used as a stand alone for 2.4gHz 


Circular polarized antenna's aka "clover leaf antennas" are a great way to increase the performance of your FPV system. Proven to increase range and video clarity, circular polarized antennas have become the standard after-market 'essential' upgrade for modern FPV systems. This is a matched 3 leaf Tx to 4 leaf Rx set with cable length for a nice clean direct install with RP-SMA connectors.


Specs:
Frequency Range: 2400~2500mhz
Impedance: 50ohm
VSWR: <1.5
Gain: 7db
Connector: RP-SMA
Cable: RG316
Cable Length: 18 inch's



Items:

1. (1) 2.4Ghz Circular polarized antenna's aka "clover leaf antennas SMA connector.

2. - (1) RP SMA Female Bulkhead to MMCX Male RF Coaxial Cable RG316 10 inches High Quality.

3. - (1) 3-D Mount with Dual Lock velcro.


 Insulation manual for the Dji Inspire1 Antenna Mod Power Booster

1. Locate the antenna hub for the Inspire 1 antennas. It should be right behind the noise of the Inspire 1. of in front of the worm gear.

2. Once you have located the hub. You will see 4 antennas connecters. 2 of them are black and the other 2 are white. The black antenna cables are for the front antennas and the white antenna cables are for the back antennas.

3. Unplug which everyone that you wish to use.

4. Once you have decided. Then plug the new antenna cable into that spot.

5. Once you have done step 4. Then rout the cable beside the inspire and underneath toward the back of the Inspire 1.

6. Then mount the antenna bracket underneath the back of the Inspire 1.

7. Then screw the antenna on.

8. Note: Make sure that you have the antenna connect to the Inspire 1 when turning on the Inspire 1 and going out of travel mode or into traveling mod.
If you have any questions about this Mod, you can e-mail me or call me.