Auto Car Lift L1100 220 volt

Warranty:

• 12 months warranty ! When you choose us, you will get the BEST warranty on eBay.
• Most of the sellers don't provide or only provide warranty for those parts for 3 or 6 months, 1 year at most. Please compare with others before you make the decision. Get into our shop and you will see the details of terms and conditions, especially the best warranty!

Auto Car Lift  L 1100

Features   220V  60HZ  1PH   3HP MOTOR

•Symmetrical Arm Assembly:

Straight Front / Rear 2 Stage reach from 30 1/4" to 49 1/5"

Equal length of front and rear arm design

Drop-in type lifting pads and truck adapters included

Safety Mechanism:

Double Point Safety Lock Release
•Automatic arm lock restraints
•Relief valve built in power pump to prevent overloading
•Door guards protection rubber
•Up-limit switch to protect cylinders working stroke used in safe length scope
•Heavy duty 5/16" diameter cable and 4.56" pulley reduce high stress on synchronization process and increase cable life
•Stiffened base plate 5/8" thickness
•Ultra high molecular self lubricating nylon slider ensures carriage smooth moving up and down
•Anchor bolts/mounting hardware included
 
Control System
•Lifting operation by pressing "UP" button on motor
•Manual lowering operation by pressing lever
•Relief valve built in power pump to prevent overloading
•1 sets truck adapters included
•Lifting Capacity: 10,000 lbs
•The overall Height  145-5/8"
•The overall Width  133-1/4"
•Column Width    10.62"
•Base Width   18.89"
•Column Thickness of Steel    3/16"
•Carriage Thickness of Steel   15/64"
•Arms Thickness of Steel     15/64"
•Front Arm    30.7" to 48"
•Rear Arm     30.7" to 48"
•Min pad height: 3-7/8"
•Lift height max: 78-7/8"
•Drive-thru width clearance: 100"
•Time to full rise: 20-60 sec
•Shipping Weight: 1460 lbs

Site Selection
Before installing your auto lift, check the following:
• Lift Location: Always use architect’s plans when available.  Check layout dimension against floor plan requirements making sure adequate space is available.  Your lift
requires a 220v, 30amp, single phase, grounded electrical source.  There should be room enough to operate the lift in a safe manner and without restrictions.
• Overhead Area: The area where the lift will be located should be free of overhead obstructions such as heaters, building supports, electrical lines, doors, lights, etc.
• Floor Area: Visually inspect the site where the lift is to be installed and check for cracked or defective concrete.

Floor Requirements
• A level floor is suggested for proper installation and level lifting.  Small differences in floor slopes may be compensated for by proper shimming.  If a floor is of questionable slope, consider a survey of the site and/or the possibility of pouring a new level concrete slab.
• New concrete must be adequately cured for at least 30 days.

DO NOT install auto lift on any asphalt surface or any surface other than concrete.
DO NOT install auto lift on expansion seams or on cracked or defective concrete.
DO NOT install auto lift on a second/elevated floor without first consulting building architect.
DO NOT install auto lift outdoors unless special consideration has been made to protect the power unit from inclement weather conditions.

Concrete Specifications
All models MUST be installed on 3,000 PSI reinforced concrete only.  Additional concrete requirements will vary by lift.

8,500 lbs – 10,000 lbs lifts: 4″ Minimum Thickness
11,000 lbs – 15,000 lbs lifts: 6″ Minimum Thickness

We ship to your confirmed address only.  You are responsible for any re-delivery charges and storage charges.  If you provide a business name, we assume you are open 8AM-5PM and can take delivery during those hours.  We are not responsible for re-delivery charges if you misrepresent being an actual business.  Any business conducted from your residence is not consider a commercial business and will be treated as a residential delivery. FREE SHIPPING TO COMMERCIAL ADDRESS WITH UNLOAD CAPACITY.RESIDENTIAL DELIVERY EXTRA CHARGE, BUT YOU CAN PICK UP FROM LOCAL TERMINAL

*Buyer must have unload equipment (i.e. forklift) available at delivery location, or you may pick up at local terminal. If buyer is not capable of unloading, we will cancel the order.*