OE replacement plastic bushing cup for the shift control lever pivot ball on manual transmission shifters found in the following Datsun / Nissan REAR WHEEL DRIVE applications:

• 1975-1988 200SX
• 1989-1998 240SX

• 1972-1973 240Z
• 1974 260Z
• 1975-1978 280Z
• 1979-1983 280ZX - non-turbo only
• 1984-1989 300ZX - non-turbo only
• Does NOT FIT turbo models
• Does NOT FIT newer models

• 1974-1979 620 pickup - 4 spd only
• 1980 720 pickup - 4 speed only
  
• 1981-1986 720 pickup - all
  
• 1986-1997 Hardbody pickup - I4 only
• Does NOT FIT V6 models (20mm OD)
• 1998-2018 Frontier pickup - all

• 1987-1988 Pathfinder SUV - I4 only
• Does NOT FIT V6 models (20mm OD)
• 2000-2004 Pathfinder SUV
• 2000-2015 Xterra SUV - all

• Transmission models include F4W71 (B-on), FS5W71 (B-on), late FS5R30A & B (1998/2000-up trucks only), FS6R30A
• Bushing has a 16mm outside diameter and fits onto a 12mm dia sphere (at bottom of shift lever)
• WARNING: early FS5R30 use a 20mm OD bushing - see separate listing
• If yours is loose or missing (!) you need one of these!
• Simple installation - remove shifter boots, remove snap ring inside housing, & lift out lever (no need to remove base)