Fender Jazz Bass wiring harness with series - parallel push/pull pot NEW!
- This wiring uses a push/pull pot in the tone position to switch the 2 pickups from parallel to series. Standard J-Bass wiring is parallel. Switching to series will give you a boost in output, and a boost in mid-range. Push Pull pot up = series, Push Pull pot down = parallel
STARR GUITAR SYSTEMS (SGS) replacement electronics for Fender Jazz Bass! Each set is assembled, hand wired and soldered in the USA by Dave Starr using premium parts. Upgrade your import bass electronics, or replace your old worn out parts with these premium replacement units! Simply attach your pickup wires, and bridge ground wire and you are ready to rock! All sets are signed by Dave Starr and have their own serial number. FREE SHIPPING IN THE USA!
Included in each JBSP system:
2) USA made CTS 250K solid shaft audio taper volume pots
1) BOURNS 250K split shaft tone pot for series/parallel switching
1) Brass sleeve to convert BOURNS tone p/p pot to solid shaft if needed
1) Orange Drop .047 Capacitor 100 volt
5) Vintage style push back black (ground) and white (hot) cloth covered wires, 22 gauge, with a waxed braided cotton outer insulation.
1) Switchcraft #11 input jack with shrink wrap strain relief on both terminals.
1) Wiring diagram (see photos above)
1) Assembly template board
Note: Most guitars manufactured overseas in South Korea, Japan, China, Indonesia and Mexico use 6mm metric pots and have metric sized holes drilled. You will need to enlarge the pot holes to 3/8" to fit these CTS pots properly.
Starr Guitar Systems
PO Box 3132
Conroe, Texas 77305
www.facebook(dot)com/starrguitarsystems
WHO WE ARE:
Starr Guitar Systems (SGS) owner Dave Starr has been playing guitar and bass professionally (WildeStarr, Vicious Rumors, and CHASTAIN) for over 30 years, and doing guitar repair for over 30 years as well. Dave has put his years of experience as a pro to come up with his own line of guitar & bass electronic upgrade systems. So, when you buy from Dave, you are not just buying gear from a guitar technician... you are buying gear from a PRO MUSICIAN who has been there and done that..... recorded over 15 albums, toured the world multiple times, MTV videos, artist endorsements (currently signed with ERNIE BALL strings and EMG pickups), etc. Every SGS unit comes with all of that experience behind it... what works and what doesn't, because Dave has pretty much seen and done it all. And, every SGS unit is custom built and assembled by hand one at a time by Dave here in his Houston Texas shop.