Feature:
Fit all drill chucks, you can get a pump with a electric drill.
Electric drill pump self priming transfer pump.
High flow, high efficiency.
Corrosion resistant.
Fine workmanship and good performance.
Small in size.
Light in weight.
Easy to install.
Specification:
Material: Engineering plastics
Pump shank: 8mm round shank
Transmission medium: oil/water pump
Self-priming: 3 meters
Impeller structure: Rubber impeller
Package included:
1 x Drill Pump
Note:
Do not run the pump in reverse.
To acquire optimum priming and long life, apply a few drops of lubricating oil in pump inlet prior to use and flush with clean water after use.
Be sure inlet hose is airtight and as short as possible. Inlet hose should not exceed 3 meter.
When pumping abrasive fluids or liquids with solids, longer pump life will be obtained by using a strainer on the inlet line.
Mount and start drill. Watch inlet tube into be certain fluid is drawn into pump in15-20 seconds. If not, check that inlet tube is properly mounted to inlet pump.
Do not run dry if pump fails to prime, check to be sure that hoses are not Kinked or clogged. Pump depends on fluid being pumped for lubrication.
Please allow a little size errors due to manual measurement.
Item color displayed in photos may be showing slightly different on your computer monitor since monitors are not calibrated same.