NOTE >>>>>
Check Part Number Before Purchasing.!
Do not Buy if you Not sure if this is Correct part and you really need it.
RETURN ACCEPTED ONLY if You Think the part is Broken or Defective .
Please Consult with Mechanic if you are not sure about fitment.IMPORTANT...
Check Part Number Before Purchasing !
IMPORTANT...
Check Part Number Before Purchasing ! 85420-20110
Only for A140E Automatic Transmissions.
PLEASE CHECK THE TYPE SOLENOID INSTALLED ON YOUR TRANSMISSION.
This transmissions comes with two types of lock up solenoids(Denso & Toyota Original). Please see the pictures,shows the type of transmissions on Vehicle bar-code ID sticker and difference between two solenoids (length,pressure holes,rubber cover). The connectors on both type of solenoids is same(in case of replacing whole transmission),but solenoids are different.
This listing for Toyota Original (not Denso) solenoid with no logo on the rubber cover.(see the pictures)
.If you need Denso solenoid ,please visit my store.Thank you.
...............................................................................................
Applications.: А140E Automatic Transmission.
T/GT-S (with ECT-S)
1994-1999 Celica GT
1983-2001 Camry/Solara 2.2 L ,(4 cyl.)
1986-1989 Celica G
1999-2001 Solara (4 cyl.)
This is TOYOTA (non-Denso) Original Factory (not aftermarket or copy)Lock-up solenoid (external-located behind the Neutral Switch,please see the pictures) for Toyota 4 cyl.,with 2.2L engine and A140E Automatic Transmission(check type of your Transmission on driver door panel bar-code stickers lower line-,please see the picture).
TROUBLE CODE:
Shift E/Lock-up Solenoid #3 Malfunction OBD II DTC code p0773.(Electrical)
NOTE.
THIS DTC CODE CAN BE ALSO TRIGGERED BY BAD Solenoid (clogged or burned),Bad ELECTRICAL CONNECTION,,Bad Converter or clutch bands,,Transmission Bad Ground connections,FAULTY ECU,Bad ECU ground connection, Bad battery ,Bad Alternator, OR ANY OTHER Electrical ISSUES!
ATTENTION !!!!!
Please Run Complete Transmission Diagnostics and live data with professional scanner!
=========================================================================
The solenoids Bench tested for resistance (12-15 ohms),Current Flow 0.80-0.95 Amp, and pressure point under load.To test ,please apply air pressure when activated.
..........................................................
//Important!
Before removing old Solenoid, please clean area by spraying with brake cleaner, for preventing any dirt from falling into transmission hole! Clean plate around the hole before installing purchased solenoid.
After installing Solenoid and just before adding the fresh ATF fluid,please clean Transmission electrical connectors ,grounds,and speed sensors (see on the picture).
Note.
If you not sure about the part fitment or repair procedures requirements ,,Please consult with your Transmission Specialist Before Purchasing this Item!
Thank You !