This is a magnetic angled single coral photo booth. This booth helps helps you take pictures of your frags. It has a built in 30° angle on the bottom which props up your frags making it even easier to take pictures. It measures approximately 3.5″ high x 2″ deep x 3.9″ wide and can hold 1 coral frag. It is open on the front, towards the glass, with an angled bottom allowing you to take direct pictures of the frag without immersing the camera in your tank. The magnets are pre-coated resin neodymium N50 high strength magnets capable of holding the rack on less than 1/2" glass (1/2" will probably work).


It is constructed solid with no holes as this is not meant to be a holding container but rather temporarily housing the frags for pictures. If you want an actual frag box you can check out the one I make here.

Please note that these are made on demand. Allow a few days from the day of purchase till I ship out.
Check my other listings for 3D printed reefing equipment. I will accept reasonable offers for multiple things bought from me.

Please note that these are 3D printed parts. That means that the surface finish quality of the part will not be directly comparable to an injection molded part. Although not very common, there might be small surface finish defects, or rough spots. The goal is to have a fully functional, as described part. This disadvantage to 3D printing is reflected on my pricing as well. Polished surface finishes, is definitely something that can be achieved to a certain degree with 3D printed parts, but it's a time consuming process, something that definitely cannot be offered for the price range my products go for.  Please also note that when dealing with acrylic, although care will be exercised, there is a chance of a small defect or scratch. It won’t be anything serious but rather minute in nature and invisible in water.