Installation:
NEED SCREWDRIVER AND NEEDLENOSE PLIERS!
Please attach the pod to the custom vent first.
1. Put washers through the screws
2. Install screw and washer and stop slightly after screw has gone slightly through the pod
3. Lineup screws that are through the vent, to the base and stop before screws go through.
4. This is the tricky part, use the nut provided and pilers to hold the nut with the furthest screw and screw together, its a tight fit, but it fits!
5. Tighten screw and nut, but do not tighten too tight!
Remove Plastic Vent by using a plastic wedge tool (recommended) or dull butter knife under the front of the vent and push down, it will pop off (some force may be required). Once its removed, you can route the pod wiring through the top of the vent. The custom vent has pockets on the sides to route the wiring through the vent and through the pods for a hidden/flush look.
!!!!!!!!DISCLAIMER!!!!!!!!
THESE PARTS ARE 3D PRINTED THE OUTER SIDE WILL BE IMPERFECT!
THESE ARE MADE TO ORDER EACH SET TAKES 8-11HRS TO PRINT IT MAY NOT GO OUT SAME DAY!