TPA-8 6-ton Hydraulic Hole Opener Stainless Steel Metal Plate Drilling Tool 22mm

Model: TPA-8

[Opening range] less than 3mm (ф16.5-60.8mm) mild steel

                      Less than 2mm (ф16.5-115.5mm) mild steel

                      Below 2mm (ф16.5-60.8mm) stainless steel

【Opening pressure】6 tons

【Travel】22mm

【Length】310mm

【Weight】6.5kg

【Packing】Plastic box

[Mold configuration] Φ22.5, Φ28.3, Φ34.6, Φ43.2, Φ49.6, Φ61.5mm

[Accessories] (1 small tie rod, 1 large tie rod, 1 set of sealing ring)

Features:

It is easy to carry, and the head can be rotated 360 degrees.

 

Product performance and use:

It is suitable for painted distribution cabinets, switch boxes, and sheet metal as a whole. The product can be flexibly replaced with molds, and the surface will not be damaged after perforation;

Other specifications can be customized according to customer needs;

When making rectangles and squares, be sure to measure the correct required size.

It is easy to carry, and the head can be rotated 360 degrees.

 

Operating procedures

1. Before drilling the workpiece, drill a guide hole of 11.5mm/20.5mm with a hand electric drill.

2. Screw the piston rod into the screw hole of the piston cylinder, and then insert the washer into the piston rod and then into the die. Then the piston rod is extended into the guide hole of the workpiece, and finally screwed into the punch to make the knife edge of the punch and the processing surface tightly combined, and the punch, workpiece and concave mold are reliably fixed.

3. Close the oil return valve in a clockwise direction, and then repeatedly press the afterburner handle to make the piston pump work, the oil pressure rises, and the shearing force between the concave and convex molds increases, and the mold cuts holes on the workpiece until the cut passes. . Stop pressing the afterburner handle immediately after cutting through.

4. Loosen the oil return valve counterclockwise to unload all oil pressure. After the above 4 steps, a complete drilling operation program is completed.

5. Unscrew the male mold, remove the waste plate in the female mold, and wipe the mold clean.