Mini Bike not included, Exhaust only.

You must know this before you make your purchase!
-There is no painting in this exhaust, Rust can come out over time, "solution" you applies high heat paint.
-This muffler is a little more Loud than the factory.
- you must use a pliers to tighten it!
-This exhaust will change color due to the high heat generated by the engine.


Please look at all the pictures to know if it will work on your application, compare all the measurements using a measuring tape to make sure it does not hit the fender or frame. Type of material: mild steel, Uncoated Steel.

- Exhaust with Muffler!
- 2 Lock washer and 2 nut included.
- Exhaust Gasket. Gasket will only work with the factory engine of the Coleman ct200u Mini Bike

Weighs about: 24oz 
This been tested on
Coleman Powersports CT200U 196cc/6.5HP mini bike.

Exhaust pipe Made in U.S.A.

We only ship to paypal confirmed address.

Florida residents pay 7% taxes.

Finding the Correct Pipe Thread Size

National Pipe Threads (NPT)

Pipe sizes do refer to physical dimensions, but the plumbing industry standard for the sizes of pipe is not always as straight-forward as measuring the pipe. Measuring the pipe will oftentimes mislead you into choosing the wrong pipe, so do take care. The "pipe thread size" as shown in column 3 of the table below is measured and based on the inside of the pipe. But, to actually determine the size of a pipe, the outside diameter of each pipe or fitting must be measured and compared to the table for size identification. For example, a 3/4" NPT pipe thread has an outside diameter of 1.050 inches. Each thread size has a defined number of threads per inch (TPI). The 3/4" NPT pipe thread has 14 threads per inch. Both the TPI (threads per inch) and OD (outside diameter) of the thread are required for positive identification of thread size because several sizes have the same TPI.

----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Please check my other Header (on other audition)