HOW TO PERFORM THE TEST:
(Before each use, flush the tester with fresh fluid )
1.
Unscrew the coolant cap to release the pressure but leave it on. To
avoid splashes and burns during the task, make sure the engine is cold!
2. Start the engine and leave it on for a few minutes to warm it up. (the coolant must be warm and circulating)
3. Fill the tester with supplied test fluid (2ml per test)
4.
Insert the tester into the radiator's or expansion's tank inlet and
observe bubbles in the chambers. You can increase the number of bubbles
by accelerating the engine. Be aware that the tester is without a
filter; accelerating could induce coolant droplets or fog into the
device and falsify the test result. In this case, the test fluid will
stay blue.
5. Don't perform the test for longer than 5 minutes. Heat is harmful to test fluid and can change the colour to green.
NOTE:
Dispose of the used test fluid (even if not changed the colour), never
mix it with a fresh one as it could affect the sensitivity of the whole
batch.
PACKAGE CONTENT:
- manual
- test tube
- bottle with test fluid ( 100ml)
- rubber bung (bottom diameter: 31mm , 45mm - top diameter)
Please check the size of the inlet in your car before ordering.
POSTAGE:
Same Day Dispatch
RETURNS:
The product must be unused and in original packaging. Buyer pays the cost of return.