Contains 2 unpainted crates, printed in very high detail UV cured acrylic plastic.

size (length x width x height) 1,2 x 0,8 x 0,5 cm (0,47" x 0,31" x 0,2")

How to work with 3D printed parts?

1. Firstly rinse in Acetone to wash off any excess waxy material. The waxy material is a support material used during 3D printing process. It is very liquid, oil-like and washes off very easily.
2. After that you can start sanding where needed. The 3D printing process builds up a product in micro-layers. Those layers sometimes remain slightly visible in some areas (especially under magnification), they can be sanded out with a medium sandpaper (like 600 grit), followed by a fine sandpaper (like 1000 grit). Again, the material is not that hard, so it sands very easy. Rinse in Acetone again to wash of any dust.
3. Some 3D printed models are hollow and open at the bottom that is normally not displayed. Should you do want to display the bottom, simply fill the part with putty and sand.
4. Now it is ready to prime and paint.

Tip for sanding very small and difficult areas

Cut a small strip of sandpaper 1 - 2 mm wide, fold it and grab it with a tweezers (not the one with a pointy tip, but the one with a flat 1 - 2mm broad tip). Hold it in such a way that the fold is sticking out for only a tiny fraction (make sure it is the fold that is sticking out, and not the loose ends of the strip). Keep holding the tweezers like that and move over the surface you want to sand. When the sandpaper is clogged, make a new fold in an area of the strip that has not been used before, and continue like before. 

We ship worldwide. Please see shipping information in the section below for the shipping costs to your country.

Combined shipping:   Combine different products in 1 shipment and SAVE!!!

first item:	8,90 USD
each additional item:	only 0,65 USD extra!!!

Contact us before purchasing if you want an estimate. 

Orders are usually shipped within 2 business days after receiving payment.

Registered & trackable shipping is possible at an extra cost. Please contact us before your purchase to get an estimate.

We accept payments through Paypal (   ).

Returned goods will be exchanged or refunded within 7 days after we have received the returned products. The costs for the return shipment can be refunded to you via a discount on your next purchase. Make sure that you are using the cheapest possible shipping method, and that you can provide us with proof of payment.
Please contact us first before returning any products to us.

Matho Models was established in 2014 and is a manufacturer of premium quality accessories for scale modellers worldwide. We also sell products from a selection of other manufacturers in our webshop.