Arduino DIY Gehäuse

Logik Level Konverter Converter Modul TXS0108E serial UART I2C SPI bis zu 110Mbit/s

txs108e 8 Channel TTL Logik Level  © androegg

 

 

simple exampleof Level converting thruTXS0108E © androegg

CH340 USB USB TTL Konverter basic ESP8266 wiring

 

 

Im Vergleich zu typischen, Transistor basierenden Logik Level Konverter mit einer typischen Geschwindigkeit von max. 28800 bit/s erreicht das TXS0108E Modul bis zu 110 Mbit/s.

 

Das TXS108E Logik Level Konverter Modul basiert auf dem TXS108 Chip von Texas Instruments. Der TXS0108E Logik Level Konverter unterstützt 2 separat, konfigurierbare Pin Leisten mit jeweils 8 Kanälen.

Die VCCA Pinleiste bildet dabei das Eingangssignal und verarbeitet Spannungen im Bereich von 1,2 bis 3,6 Volt. Die VCCB Pinleiste erlaubt Eingangsspannungen von 1,65 bis 5,5 Volt.

Zu beachten:

Das TXS0108E Logik Level Modul kann sowohl im Low als auch High Impendance Modus (OE Pin mit GND belegen) betrieben werden.

Typical Logic Level Converter Modules are based on Transistors and max. Transferrate is limited to 28800 bit/s. Compared to typical Logic Level Modules the TXS0108E Module supports transfer rate up to 110 Mbit/s.

 

The TXS108 8-bit non-inverting translator uses two separate configurable power-supply rails. The A port tracks the VCCA  pin supply voltage.

The VCCA pin accepts any supply voltage between 1.2 V and 3.6 V. The VCCB pin accepts any supply voltage between 1.65 V and 5.5 V.

 

Notes:

The output-enable (OE) input is low, all outputs are placed in the high-impedance (Hi-Z) state.

Ihre Vorteile

  • wir berechnen Nur 1 mal Versandkosten (ganz gleich wie viele Artikel)
  • Versand erfolgt 6 Tage die Woche (mo.-Sa.)
  • Bestellungen bis 12:00 Uhr Versand noch am gleichen Tag
  • Fragen oder Problemen? kurze Nachricht genügt

 

your benefit

  • we only charge shipping costs once
  • we ship 6 days a week (Mo. - Sa.)
  • Orders before 12:00 same day shipped
  • Questions or Problems? Just send a message

8 Channel TTL Logic Level Converter Features:

  • No Direction-Control Signal Needed
  • Maximum Data Rate
    • 110 Mbps (Push Pull)
    • 1.2 Mbps (Open Drain)
  • 1.2 V to 3.6 V on A Port
  • 1.65 V to 5.5 V on B Port
  • No Power-Supply Sequencing Required
    • Either VCCA  or VCCB  Can Be Ramped First
  • Latch-Up Performance Exceeds 100 mA Per