This is a sealed hard plastic three piece case that allows the RC receiver to be protected from water. It is mounted from below, and can be attached by screws, or with double sided foam tape. 

All wires come through a hole in the top, which is also covered by a splashproof shield. 

This will fit many cars but is especially good for early versions of tyhe Thunder Tiger TS4N cars which have exposed receivers.

The package includes the following:

- Bottom Casing
- Top Casing
- Wire Hole Cover
- Silicon Seal
- Screws

Will fit most RC Receivers.

Note - The servo and reciever in the pictures are for show only and not included with the sale.

I have many more car / truck / buggy  parts for sale, please check my other listings.

Brand New Item.


Unless otherwise stated, parts have been taken from a vehicle broken for spares. All parts have been cleaned and lubricated where necessary. Some parts may have minor cosmetic scuff marks from usage.


Buy With Confidence :-
I have been involved with Radio Control models for many years, and have built up a wealth of knowledge on many Nitro vehicles, both old and new. 
Please review my feedback for customers comments.

Many parts are interchangeable between models. I have a stockpile of spares both new and used for all makes and models of Nitro RC Vehicles, so if you are looking for something specific, please ask.

I also fully refurbish Nitro RC models for resale, so if you are looking for a used but reliable Car /Truck or Buggy, these are listed on a weekly basis.

Note:-
Packaged items are sold on a 30 day return basis, and returns will be accepted provided the packaging is unopened.  
Used or second hand spares are sold as seen, and are non returnable. (unless by prior agreement)

I would ask the winner to please pay promptly within 24 hours of purchase. If this is not possible please contact me. All items are sent via Royal Mail or Insured courier service.

 Please feel free to ask any questions, I will endeavor to answer them promptly both before and after the sale.