Made in the USA
HUBCAP DECAL SET for 4 Caps
EASY PEEL AND STICK
These decals are designed to cover/replace worn paint on hubcaps in the picture that measure about 10.5" wide in the back and are typically painted white. Use these decals to refresh and renew your hubcaps.
These are designed to be installed in sections by simply peeling and sticking the decals.
APPLY TO A CLEAN, DRY AND COOL TO THE TOUCH SURFACE.
If you have wax or tire gloss on the hub cap nothing will stick to it. Remove all wax, tire gloss and cleaning residue
- Remove one decal at a time with an exacto knife or toothpick if neither are available you can do this with your clean, dry and lotion free fingers.
First install 6 black T's, next install 6 black moons (this encloses the outside black ring).
Then install black half shields (2 pcs designed to install in half pieces).
Finally the goldish tone bowtie.
There is no need to use a solution to install these decals but you certainly can using the following instructions:
INSTRUCTIONS if you choose to use a solution:
APPLY TO A CLEAN, DRY AND COOL TO THE TOUCH SURFACE.
- If you have wax or tire gloss on the hub cap nothing
will stick to it. Remove all wax, tire gloss and cleaning residue
- Remove one decal at a time with an exacto knife or
toothpick if neither are available you can do this with your clean, dry
and lotion free fingers.
- Create a solution to easily move the decal before you
place it on the hubcap using 1 tablespoon of dishwashing liquid to one
gallon of water and shake well
- Be careful not to stretch the decal upon removing from
the backing using an exacto knife, boxcutter or clean dry and lotion free
fingers
- With the solution wet the area very well where the
decal will be placed and the sticky part of the decal (make sure the decal
has been removed from the backing before wetting do not wet the decal
while on the backing)
- Place the decal into position
- Quickly moisten a finger (with solution) and use that
wet finger to move and press the decal in to position
- Remove extra liquid and any air bubbles by pressing the
air bubble or extra liquid to the nearest edge using your wet (with
solution) finger or a debit/credit card being careful not to scratch the
decal
- Use a paper towel, napkin, microfiber and a dry finger
to remove excess solution
- Repeat process for all decals
NO HARD PARTS ARE INCLUDED IN THIS SALE
DECALS ONLY