HPE 3PAR 7200c All Flash 10.8TB SAS SSD 10Gbit iSCSI Gen9 40-Core SAN Solution
*** 3 Year Replacement Warranty on ALL Hardware! ***
Keep in mind we offer '3 Year Set up & Support'. We have a very experienced on site technician who has installed and operated this type of hardware for over 10 years who you can contact for support during the installation or for assistance whilst operating this hardware.
HP 3PAR StoreServ 7200c 2-Node All Flash SSD 10GBit SAN With 2x DL360 Gen9 Rack Server Configuration.
You have 8.1TB usable capacity! You can see storage breakdown in the images.
Both servers have 20-Cores & 256GB DDR4 RAM.
You are bidding on a very fast, versatile and redundant SAN Storage Solution using HPE best of class products by combining the HPE DL360 Gen9 Servers with the amazing HPE 3PAR 7200c SAN Storage Array.
If you don't know much about HPE 3PAR and why the technology is revolutionary to the SAN Storage and Storage sector as a whole, I've outlined a few major advancements compared with traditional SAN Storage Arrays and RAID technology:
· HPE 3PAR Storage Arrays cut the spinning hard disk drive and SSD drives into 1GB chunklets automatically as soon as the hard drives are inserted into the array. Physical disks are divided into chunklets. When a physical disk is admitted to the system, it is divided into chunklets that become available to the system. Some chunklets are used by Logical Disks. Other chunklets are designated as spares, to hold relocated data during a disk failure or during maintenance procedures.
· Each chunklet occupies contiguous space on a physical disk. Space on a physical disk is allocated as follows: All chunklets are 1 GiB; 256 MiB of space is reserved for the table of contents (TOC), which contains the internal description of the system. The TOCs on all physical disks in the system contain the same information; 4 MiB of space is reserved for diagnostic use-2 MiB beginning after the TOC and 2 MiB from the end of the disk logical block address; One or more chunklets are allocated as spares. Any chunklet can be reserved as a spare, but the system setup script selects those chunklets as close to the end of the physical disk's logical block space as possible; The remainder of the disk can be used for Logical Disks.
· Spare Chunklets Explained - Some chunklets are identified as spares when the system is first set up at installation. Data from other chunklets is moved or reconstructed to these spare chunklets in response to a chunklet or disk failure or when a drive magazine must be serviced. This initial spare storage is equal to the amount of storage in a single drive magazine, using the largest size physical disks.
· A Logical Disk (LD) is a collection of physical disk chunklets arranged as rows of RAID sets. Each RAID set is made up of chunklets from different physical disks. LDs are pooled together in Common Provisioning Groups (CPG), which allocate space to virtual volumes. Creating CPGs maps out the data layout parameters for creating LDs. LDs are created automatically by the system when virtual volumes are created from CPGs. The RAID type, space allocation, growth increments, and other LD parameters can be set when you create a CPG, or can be modified after you create a CPG. For information about CPGs.
One of the most amazing parts of HPE 3PAR Chunklet technology is that you can lose a whole disk shelf to either power failure or disk loss and you still don't lose your data. This is because there is a rule when the Chunklet RAID Sets are created when you setup your CPG. The array will not let more than 2x 1GB Chunklets from the same Chunklet RAID set reside on the same hard drive or disk shelf. This means that using either RAID1, RAID5 or RAID6 for your CPG's, you will be able to tolerate the loss of a full disk shelf without losing your data or having to bring your 3PAR SAN Storage Array offline.
Another great feature if that you don't have to group disks into RAID sets of the same sized disk anymore. Because 3PAR splits the disk into 1GB chunklets, as long as you have the same speed disk in the same RAID sets, you can group all sorts of sized disks together. For example, you could have a CPG of 146GB, 300GB, 450GB, 600GB, 900GB or 1.2TB 10K RPM and or 15K RPM hard drives with no problem, because they are of the same speed RPM (You can have 10K and 15K RPM drives in the same CPG). It's the same for the 7.2k RPM drives.... You could have a mixture of 1TB, 2TB, 3TB, 4TB, 6TB or 8TB 7.2k RPM disks in the same CPG, again, because they are of the same RPM speed... Sizes doesn't matter because your 3PAR array cuts your disks into 1GB chunklets! It's the same for SSD's! You can mix the same speed SSD's in the same CPG's!
Another amazing part of 3PAR technology is "Peer Persistence" - If you have 2x HPE 3PAR Array in the same data centre or even at separate colocation facilities, you can group them together into a "Peer Persistence Group". This bascally means that you can present 2x SAN Storage Arrays as 1x Storage array to your HOSTS!! Your hosts think there is just one array using 1x WWN number for then SAN, when in fact there is 2x 3PAR SAN Storage Array. One is the Master Array and one is the Standby Array. In the event of a major disaster, like a power outage to the Master Array, the Standby Array will take over instantly, with no affect felt by your hosts! True SAN failover WITHOUT the setup complexities of old technologies like the old HPE EVA Continuous Access. The 3PAR Arrays do not need to be of the same model or age, you could have a HPE 3PAR 7200c and a HPE 3PAR 8400 in the same Peer Persistence Group.
This HPE 3PAR 7200c comes fully licensed with the following features enabled:
- 3PAR OS Suite
- Adaptive Flash Cache
- Adaptive Optimization
- Data Encryption
- Dynamic Optimization
- Management Plug-In for VMware vCenter
- Peer Motion
- Peer Persistence
- Priority Optimization
- Recovery Manager for Exchange
- Recovery Manager for Microsoft Hyper-V
- Recovery Manager for Oracle
- Recovery Manager for SQL
- Recovery Manager for VMware vSphere
- Remote Copy
- System Reporter
- System Tuner
- Thin Conversion
- Thin Copy Reclamation
- Thin Deduplication
- Thin Persistence
- VDS Provider for Microsoft Windows
- Virtual Copy
- Virtual Domains
- Virtual Lock
- VSS Provider for Microsoft Windows
This solution is ideal for storage DRS as it has both spinning disk's and SSD's. DRS is the resource scheduling and load balancing solution for vSphere, it works on a cluster of ESXi hosts and provides resource management capabilities like load balancing and virtual machine placement. When Storage DRS is enabled, it provides recommendations for virtual machine disk placement and migration to balance space and I/O resources across the datastores in the datastore cluster. DRS strives to keep your VMs happy.
Both servers have 1x Dual Port HP 10Gbit SFP+ Ethernet Fibre Card installed that connect to the Cisco Nexus 5010 20-Port 10GB Gigabit Ethernet Switch. This is the network switch you'll be using for your 10Gbit iSCSI SAN network traffic, but you could also VLAN segment it for normal network traffic as well.
The Cisco Nexus 10Gbit Ethernet Switch is a Layer-2 Networking switch with VLAN capability so you can hook this switch up to the rest of your core network if needed using SFP+ 10Gbit Modules.
The DL360p Gen9 Servers have 1x 4-Port 1Gbit 331FLR FlexLOM NIC cards to connect the servers to your existing core Ethernet network.
Grab yourself a VERY FAST very cheap full blow SAN/Server solution!
All the hardware has been reset back to
factory defaults with default passwords. You're ready to plug and play!
Configuration:
2x HP DL360 Gen9 2x E5-2650v3 256GB P440ar/2GB FBWC 4-Port 1Gbit 331FLR 2x 800W 2x 146GB 15K SAS 1U Servers
2x HP NC523 Dual Port 10Gbit Ethernet Network Adapter with 2x SFP+ 10Gbit Installed
1x QR511A - HP 3PAR StoreServ 7200 2-node Storage Base
2x QR487A - HP 3Par StoreSer PCIe Dual Port 10GB iSCSI FCoE Network Adapter
4x QR490A - HP 3PAR M6710 2.5 inch 2U SAS Drive Enclosure
60x QR503A - HP 3PAR M6710 200GB 6G SAS SSD Hard Drive
2x Cisco Nexus 5010 20-Port 10GB Gigabit Ethernet Switch + 20x 10GB SFP's
2x HP DL360 Gen9 Rack Rail Kit
5x HP 3PAR 7200c Rack Rail Kit
4x 2 Meter LC-LC Multi Mode Fibre Cables
10x HP External SAS 2 Meter Cables
SERVERS
2x HP DL360 Gen9 2x E5-2650v3 256GB P440ar/2GB FBWC 4-Port 1Gbit 331FLR 2x 800W PSU 2x 146GB 15K SAS 1U Server
(2 of the below configuration)
1x 755258-B21 - HP DL360 Gen9 2x Heatsink 7x Fans 0GB B140i/ZM 0PSU 8SFF 1U Rack Server
2x SR1YA - Intel Xeon E5-2650v3 10-Core 2.30GHz Processor
16x 726719-B21 - HP 16GB (1x16GB) Dual Rank x4 DDR4-2133 CAS-15-15-15 Registered Memory Kit
1x 726736-B21 - HP Smart Array P440ar/2GB FBWC Array Controller
1x 684208-B21 - HP 1GbE 4-port 331FLR Adapter
1x 727258-B21 - HP DL/ML/SL 96W 145mm Smart Storage Battery
2x 720479-B21 - HPE 800W Flex Slot Platinum Hot Plug Power Supply Kit
2x 652605-B21 - HP 146GB 6G SAS 15K SFF (2.5-inch) SC Enterprise
1x 734807-B21 - HP DL360 Gen9 1U SFF Rail Kit
1x 593717-B21 - HP NC523SFP 10Gb 2-port Server Adapter
2x 455883-B21 - HP BladeSystem 10Gb SR SFP+
STORAGE
1x HP 3PAR StoreServ Dual 10Gbit All Flash (60x 200GB SSD) SAN Solution
1x QR482A - HP 3PAR StoreServ 7200 2-node Storage Base
2x QR487A - HP 3Par StoreSer PCIe Dual Port 10GB iSCSI FCoE Network Adapter
4x QR490A - HP 3PAR M6710 2.5 inch 2U SAS Drive Enclosure
60x QR503A - HP 3PAR M6710 200GB 6G SAS SSD Hard Drive
5x 692981-001 - HP 3PAR Rack Rail Kit 2U for StoreServ 7000
10x 407339-B21 - HP External Mini SAS 2m Cables
4x LC-LCMM2M - LC-LC Multi Mode 2M Fibre Cables
NETWORKING
2x N5K-C5010P-BF - Cisco Nexus 5010 20-Port 10GB Gigabit Ethernet Switch
40x SFP-10G-SR - Cisco 10GBASE-SR SFP+ Module
The HP SAN Controller is capable of RAID 0 RAID 0+1 RAID 5 RAID 6-ADG RAID 10 RAID 50 RAID 60 logical drive configurations
Additional options can be purchased from our HP
Refurbished stock holding of over 15,000 items!
Hard Drives
Memory
NIC Cards
Fibre/SCSI HBA Cards
And many more.........
This server/storage configuration comes with an "Intelligent Brokerage Limited 3 Year Any Parts Replacement Next Business Day Warranty".
SD
Warranty & Support
All hardware purchased is covered with 3 Year Hardware Replacement Warranty - This includes all components installed.
At Intelligent Servers, we're confident that our refurbished servers are as good as new. That's why we offer a free, industry leading 3-year warranty on all products. In the unlikely event your product doesn't work as it should, we'll also offer you a hardware replacement with next-working-day delivery in the UK and 1-3 day delivery for Europe. If you have any issues deploying, configuring, connecting or migrating your hardware into your current infrastructure, our experienced team of IT professionals can offer free remote set up support - we're only a phone call away!
EU VAT
Shipping to the European Union (EU) from the United Kingdom (UK) has changed since the UK left the EU's single market and customs union in January 2021. This means that customs declarations and additional charges may be required for goods being shipped from the UK to the EU. These charges may include VAT, customs duties, and handling fees, and are the responsibility of the buyer. Shipping times may also be affected due to increased border checks and delays. It is important for both buyers and sellers to be aware of these changes and to ensure that all necessary documentation and charges are included when shipping to the EU from the UK. To avoid any potential issues, it is recommended that buyers and sellers consult with their respective customs and shipping authorities before proceeding with any international transactions.
If you are a Business customer, please enter your EORI number in the "Notes To Seller" upon checkout. An EORI number is required for all UK to EU business transactions. If an EORI number is not provided, your parcel is at risk of delivery failure.
Returns
Returns are accepted within 30 days of the delivery date, provided that the item is unused, in its original packaging and in the same condition as when it was shipped. The buyer is responsible for all return shipping costs, unless the item was received damaged or defective. If the item was damaged during shipping, please contact us immediately to arrange for a replacement or refund. Refunds will be issued within 3-5 business days of receiving the returned item, provided that it meets the above criteria. We reserve the right to refuse any returns that do not meet our criteria or that are returned without a return authorization number.
About Us & Contact
Founded in 2011, IntelligentServers.co.uk is one of Europe's leading refurbished Server, Storage, Networking and Component resellers, specialising in HPE, Dell and Cisco. With over 10 years' of experience refurbishing all aspects of used enterprise IT hardware, you can trust in Intelligent Servers to deliver your IT hardware on time and to a grade A refurbished standard. Our website and ethos has been designed around the IT technician. We understand the strict deadlines and project commitments an IT Manager has to deal with a day to day basis, this is why we've become a very successful competitor within the refurbished enterprise computer hardware industry, and we'll continue to strive to become the best in our game.
If you have any questions at all, don't hesitate to get in touch - Call +44 01423 223430
