High Quality Premium Heated Handlebar Grips

5 temperature settings mean that you can adjust the heated grips with a single click. The switch can be mounted to the bars or fixed to panels with the adhesive strip that is supplied

Power level 1: 41.85W

Power level 2: 43.74W

Power level 3: 44.96W

Power level 4: 45.5W

Power level 5: 45.9W

12v Power Supply

120mm Grip Length (Left Internal Diameter 22mm , Right Internal Diameter 25mm) - heating power adjustable in five stages

The rubber compound is resistant to all weather conditions and is a brilliant necessary addition for cold conditions, these make a considerable difference to your comfort on cold journeys

Grips are open ended to allow hand guards, bar end weights and lever guards to be used. Blanking caps are also supplied if you wish to have closed ends.

Fitment

1/ Fit the grips onto the bars, rotating them so they do not make contact with the levers.

2/ You need to make sure the Right grip does touch the lever when twisting the throttle. 

3/ Once happy with position, remove the grips one at a time and apply the glue inside the grips

4/ Slide the grip back into position and allow to set.

5/ Run the wires that come from the grips along the handlebars & cable tie the wires as you go . Do not over tighten them. Also make sure not to cable tie the wire on the throttle side near the grip because you wont be able to twist the throttle

6/ Continue to fit the wires along the head stock & under the tank. Make sure to avoid parts of your bike which are hot and that the wires do not pull on the throttle/clutch cables

7/ Connect the second half of the wiring to the wires from the heated grips. 

8/ Once you have reached the battery connect the black wire to the earth/negative side.

9/ Wire the positive wire into a live feed after the ignition is switched on therefore avoiding the possibility of draining the battery if you accidentally leave the heated grips turned on. 

10/ Usually the easiest live wire to choose will be the rear brake light switch.