I make these custom bail springs by hand in my workshop from
stainless steel spring wire. I have been making bail springs for approximately
20 years for use in my various reels. They function like factory made ones and
have essentially the same use life. I’ve
been selling bail springs on eBay since 2014. I’ve had a 99% plus rate of
success with their quality. If you have an issue with the installation or
function of a spring, please contact me immediately. I will work to make things
right to your satisfaction.
FIND MY OTHER CUSTOM MADE BAIL SPRINGS BY CLICKING ON “See
Other Items”.
BAIL SPRING INSTALLATION:
1. Remove spool from reel.
2. Loosen or remove bail trip screw and bail trip
lever or bail stop mechanism.
3. Remove bail screw and remove broken bail spring.
4. Put new bail spring into slot in the rotating
reel head.
5. Rotate bail down past the bail stop and engage
bail spring tab into the bail.
6. Bring the bail back into the normally closed
position while keeping the bail spring engaged.
7. Screw the bail screw back into the reel head.
8. Tighten or re-install the bail trip lever screw
and lever or bail stop mechanism.
9. Test the bail to determine if it is working
properly.
If the bail is not working
properly, check for the following:
1.
The bail spring tab is not
engaged in the bail. The bail will not have any spring action at all. Repeat
the installation process.
2.
The tab
that sticks up into the bail is too long and is scraping on the screw head. These springs have all been trimmed so that
should not be an issue.
3.
The spring
is pinned between the bail and the bail post. This is easy to do. I did this on
about half of the installations I did with my Garcia Mitchell 408s. With this
situation the bail will hardly move. The
bail screw must be loosened and the process repeated.
The last situation is
that the bail is sprung. With this situation the bail and the bail screw rub on
each other and reduce the free play of the bail. Here is an easy way to
determine if the bail is sprung. Loosen the bail screw several turns. If this
frees up the movement of the bail, the bail is sprung. If the bail is sprung, it will need to be
re-sprung into a non-binding position.
I combine ship. I charge the full shipping and handling
amount for the first item and then $1.00 for each additional item.