Complete custom wiring harness
For Gibson Les Paul
No soldering required
Completely wired (not a kit) and ready to drop into your axe.
Made in USA
Special features:
For models with LONG SHAFT POTS and LONG FRAME SWITCH
Custom oil filled tone capacitors - handmade to vintage spec's
Solderless installation
Bourns Pro-audio 18mm push/pull potentiometers
Multi contact jack with 100% more signal transfer area
Shielded cable to switch & jack to protect your signal from interference (noise) -
2 grounding options for strings & outer hardware
Switchcraft LONG FRAME toggle switch
Custom Jimmy Page push/pull switching without dead zones:
Coil split for Neck
Coil split for Bridge
Reverse Phase
Series / parallel
* See important pickup wiring info at bottom of listing
Installation:
This system makes upgrading your electronics with premium components easy, quick and frustration free. It's the easiest installation & future pickup swap system available.
1- Slip your stripped wires into the solderless terminal ports and secure with the included 2mm screwdriver.
2- mount your new harness in the control cavity
3- plug the solderless terminal into the harness.
BING - BANG - BOOM - DONE!
Plus, no burned fingers!
***Makes future pickup upgrades a snap***