This compressor can be mounted just about anywhere in your vehicle as there is no need for a belt or mechanical drive!

You can mount these compressors in an engine bay, a boot / trunk, under a tray of a ute / pickup or truck! 

You will need a decent alternator with an output of at least 100A and up to manage the 66 Amp current draw that this compressor will require at its full speed rated at 4000rpm.

Comes with a set of Suction & Discharge pad to MIOR adaptors to allow the use of standard FOR screw on fittings. 

Discharge is #8

Suction is #10

Displacemant = 12cc

RPM / 3 Speeds = 1st speed 3000rpm / 2nd speed 3500rpm / 3rd speed 4000rpm

Low displacement combined with high rpm = efficiency.

Max Cooling = 1940 Watts / 6689 BTU

Controlling the compressor

Using the vehicles air conditioning thermostat located in the factory evaporator box / under dash unit to trigger a mini relay. (Not included but can be supplied separately)

Wiring diagram will be supplied either physically or by e-mail.

Powering the compressor

You will require the following items / these are not included (We can supply these, please see our store or just ask us).

1. 100A MIDI Fuse and holder

2. Continuous duty solenoid

3. 6 B&S Cable per metre depending on where you mount the compressor

4. Mini relay

Overall compressor dimensions

Width 123mm

Length 173mm

Height 154mm

VERY IMPORTANT *COMPRESSOR HAS TO BE MOUNTED AS IN PHOTOS WITH THE TROUGH BOLT MOUNTING POINTS AT THE UNDERSIDE OF THE COMPRESSOR, THIS CAN NOT VARY OTHERWISE COMPRESSOR WILL SUSTAIN DAMAGE OR FAIL*