STARR GUITAR SYSTEMS Epihone Viola Bass Wiring Harness Upgrade with pickup Balance/Blend control!

This set up allows you to blend/balance between neck and bridge pickups.

Included in each SGS EVBVBT system

1) BOURNS 250k Audio Pot for master volume, split shaft, with Nut, Lock and Dress Washer.
1) CTS 250K Blend/Balance Linear Taper Pot, with Center Detent, with hardware.
1) BOURNS 250k Audio Pot for master tone, split shaft, with Nut, Lock and Dress Washer.
1) "Orange Drop" .047 mfd PIO Capacitor 100 volt
5) Gavitt PVC coated wires, 22 gauge
1) Switchcraft #11 input jack with heat shrink strain relief on both terminals
1) Wiring diagram (see photo section)
1) Assembly template board

NOTE: 34mm measurement from center to center of each pot

Premium replacement electronics for your Epiphone Viola Bass! Each set is assembled, hand wired and soldered in the USA using premium parts. Upgrade your import bass electronics, or replace your old worn out parts with these brand new replacement units! Simply attach your pickup wires, bridge ground wire and you are ready to rock! All sets are signed by Dave Starr and have their own serial number.


Note: Most guitars manufactured overseas in South Korea, Japan, China, Indonesia and Mexico use 6mm metric pots and have metric sized holes drilled. You might need to enlarge the pot holes to 3/8" to fit these BOURNS pots properly.