Custom Jimmy Page wiring harness for Gibson Les Paul
No soldering required
Completely wired (not a kit) Ready to install
Charlies Gear USA
Series / Parallel / Phase / Coil split - with no dead zones
Special features:
Solderless installation
For Gibson Les Paul models with Long shaft potentiometer & Long frame switch
Authentic Bumblebee Paper In Oil tone capacitors
Bourns pro-audio series push/pull potentiometers - LONG SHAFT for thick Gibson top
Multi contact jack with 100% more signal transfer area
Shielded cable to switch & jack to protect your signal from RF interference noise
2 grounding options included for strings & hardware
For 2 (4 or 5 wire) humbucker pickups (HH) - See important wiring info at bottom of listing
LONG frame 3-way toggle switch
Pull up or push down your knob for these push/pull functions:
1- Series/parallel (neck tone, pull for series)
2- reverse phase (bridge tone, pull for phase)
3- coil split bridge (bridge volume, pull to split)
4- coil split neck (neck volume, pull to split)
Please note component measurements shown in photos to make sure they will fit your model.
Feel free to ask for help with any questions you may have or modifications you need.
Installation:
This system is designed to make upgrading your electronics with premium components easy, quick and frustration free.
1- Simply slip your stripped wires into the solderless terminal ports and secure with the included 2mm screwdriver.
2- mount your new harness in the control cavity
3- plug the solderless terminal into the harness.
BING - BANG - BOOM - DONE!
Plus, no burned fingers!
***Makes future pickup upgrades a snap***