We are professional industrial&electronic Categorie manufacturers in China. We have been working in this field for almost 10 years!
Our products include all kits&welded products for Andruino, Raspberry Pi, or mini flights.
If you have any needs, pls contcact us for free, we will help you get all things you need.
Thank you !

Product View

MAIN PRODUCTS

              STC-1000  

 LCR Transistor Tester 

   ESP8266 ESP-12F

Raspberry Pi

PH Meter

Relay Module

TL866II Plus

SG90

Product Details

18650 Battery Shield V3
Features:
Battery protection(Over charge or Over discharge)
Micro USB port Input
Type-A USB Output
0.5A current charging
1 switch control USB output
5~8V Input Voltage
3V & 1A Output
5V & 2A Output
LED indicate(Green means full,Red means charging)
3V output port x3
5V output port x3
Be careful of "+" and "-", You should follow the direction of "+""-" on the PCB.
Size: 9.8x2.9cm/3.86x1.14inch
Optional:
Battery Shield+Cable
Battery Shield
1.Please allow 1-5mm error due to manual measurement. pls make sure you do not mind before you bid.
2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!
3. If you put wrong direction, charging chip will be destroyed.
4.This product does not include 18650 battery
Package included:
1 x Battery Shield Module with Cable or not (battery not include)
 
 
18650 Battery Shield V8
Description:
 
This module is a portable mobile power supply that supports 3V / 1A and 5V / 2.2A two voltage outputs!
5V voltage output rated current is 2.2A, maximum support 3A current (not recommended for overload, easy to damage the module, speed up the service life), the output of current depends on the quality of the 18650 battery!
 
MICRO USB charging current 600mA-800mA,
Supports up to two 18650 batteries. It is recommended to use two 18650 batteries, which can be longer!
 
Special attention: the installation of the battery must be determined positive and negative, the board has been clearly marked positive and negative! Installation errors will burn out the module!
 
Package Included:
 
1*Mobile Power Bank 18650 Battery Shield V8 5V Micro USB for Arduino ESP32 ESP8266
  • We accept PayPal only. But we only Accept your Ebay Address,Please Make sure it's 100% right.
  • Payment must be received in 5 business days of auction closing.
  • Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
  • Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
  • All package need to wait 30 days(US only need 7-10 days),Please take care it.Less than 30 days,we can't take a refund.
  • If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
  • If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.

DataCaciques