Custom printed circuit board designed for the crossover of the Argos DIY speaker design.

Take the guesswork out of crossover assembly, these boards make the assembly process quick and straightforward.

These boards measure 5.5" x 4.25" and features large solder pads and copper traces for great electrical connectivity

Note - Photos of fully assembled crossovers are for reference only.

Note - This listing has been revised from a pair of boards to single board in order to allow the purchase of these boards in an increment of 1 if odd numbers are required.

Includes:

1x Crossover PCB for the Argos speaker design.

3x Terminal blocks which accept up to 12 gauge wire.

4x Snap in PCB standoffs.

4x Mounting screws (screw finish may vary).

Requires:

Crossover components for the Argos speaker design.

Compatible components tested for fit on this PCB: 

C1 - 2uF - Dayton Audio DMPC-2

C2 - 3.3uF - Dayton Audio DMPC-3.3

C3 - 12uF - 12uF 100V Electrolytic Non-Polarized Crossover Capacitor

C4 - 33uF - 33uF 100V Electrolytic Non-Polarized Crossover Capacitor

C5 - 68uF - 68uF 100V Electrolytic Non-Polarized Crossover Capacitor

L1 - 0.50mH - Dayton Audio 0.50mH 20 AWG Air Core -or- Jantzen Audio 0.50mH 20 AWG Air Core

L2 - 1.0mH - Dayton Audio 1mH 18 AWG Air Core -or- Jantzen Audio 1.0mH 18 AWG Air Core

L3 - 0.30mH - Dayton Audio 0.30mH 20 AWG Air Core -or- Jantzen Audio 0.30mH 20 AWG Air Core

L4 - 0.40mH - Dayton Audio 0.40mH 18 AWG Air Core -or- Jantzen Audio 0.40mH 18 AWG Air Core

R1 - 15 Ohm - 15 Ohm 10W wire wound resistor

R2 - 5 Ohm - 5 Ohm 10W wire wound resistor

R3 - 20 Ohm - 20 Ohm 5W wire wound resistor

Assembly:

Glue components to the correct positions on the board (hot melt glue works great). Secure inductors with non metallic cable ties. Solder components leads to the pads on the bottom of the board. Attach wires from input and drivers and mount crossover board.