Ring Alarm Motion Detector (1st Gen only) wall mount. Indoor only

Corner mounting.  Can also be mounted on flat wall for 45 degree view. (see photos)

Minimalist design that uses the small Command strip. 

No screws, pins, no damage to the wall, or paint. Mount it anywhere with a smooth flat surface. Change your mind? Remove it, apply a new strip, and install it again.

What you get is 1 holder with a small command strip. If you change your mind on the mounting location you can buy new strips from just about anywhere.

This is only a mounting bracket. you will not get a sensor. Photo for reference only. NO sensor included. 

If you are familiar with Command strips, then you already know how this works, and how well it works in protecting your wall paint.

Mounting brackets only require 1 Command strip. The corner mount is designed with both left or right mounting options, that's why you see 2 places where you can mount the strip. You only need one. Some users actually use the corner mount on a flat wall, so I designed it to face either direction when used on a flat wall. Use only 1 strip for corner mount. Corner drywall is almost never completely 90 degree. You'll likely only have good contact on 1 wall only. 

Caution: I've been using the command strips/hooks in my house for a long time now. It has never taken paint with it during the removal process. However, if you google, you will see some reviews that state damaged paint. So please follow the manufacturer's instructions on install and removal of the strips and just be as careful as you can. Obviously, I can not guarantee that the Command tape will never damage your paint, I can only tell you that my wall is perfect after removal of the tape. And I use these (small to large) all over the house. Just make sure you follow Command's instructions.