2nd Order (12dB / Octave) Crossover Board - can be configured as either a 2-way (highpass/lowpass for tweeter & woofer) or as bandpass (midrange)

Custom printed circuit boards designed for general purpose DIY speaker crossovers or rebuilding crossovers.

These boards are designed to give a clean layout and allow for easy crossover assembly. 

*NOTE - No crossover components are included*

This 2nd order (12dB/Octave) crossover board can be used as either a 2 way crossover with a highpass and lowpass or conffigured as a single bandpass crossover for a midrange.  

For 2-way use: bridge the solder pads marked 2-way then connect the tweeter to the HF outputs and woofer to the LF outputs.

For bandpass use: bridge the solder pads marked bandpass then connect the midrange (or other speaker driver being used) to the LF outputs. The HF outputs are not used in the bandpass configuration.

This board comes with two different capacitor through hole positions available for smaller or larger size capacitors and the inductor or coil is designed for air core style.

These boards measure 4.5" x 4" and feature large solder pads and copper traces for great electrical connectivity.

Includes:

1x 2-Way/Bandpass PCB

4x Snap in PCB standoffs.

4x Mounting screws (screw finish may vary).

Assembly:

Glue components to the required positions on the board (hot melt glue works great), Use non metallic cable or zip-tie to further secure the coil and solder the leads and input/output wires to the pads on the bottom of the board.