Car Tires Studs Spikes Wheel 12x8mm Snow Chains For Vehicle Truck MotorcycleX100
Description:
Material :aluminum
SIZE:As the picture shows(8-12-1)
The new style screw in tire studs can be easily installed and removed
without professional tools, it can also be disassembled according to the
reason, When not in use,
it could be removed lightly and stored for
using again in th following season. Choose appropriate size of new
studs in the installation process in terms of the depth of tire thread.
Easy to install and remove - less than 1 hour with simple hand tools
Economic - add ultimate off-road capability to your "normal" ATV,UTV or 4X4
Low ground pressure - environmentally with minminum impact
Proven - world renowned product
Durable - quality engineering, built to last
Versatile - all reason capability in all condition
How to install the tyre studs?
Certain equipment is necessary to insert tire studs correctly. In addition to a snow tire with pre-drilled holes for studs,
you also need the correct size stud. The tire stud number size is
located on the sidewall or on the tire label of the snow tire.
Using
a smaller stud than stated can result in an ineffective stud, and one
that's too long can cause the stud to dislodge from the tire.
A stud
gun, a pneumatic device that resembles a hand gun, is used to insert
the stud into the hole in the tread of the snow tire.
1.Drill (using a very small bit) down from the center of chosen knob into the tire
2.Drill a screw up from inside-out. If the angle isn't perpendicular to the tire, it'll stick out one side or the other.
Do one hole and screw at a time. Don't try drilling all the holes, then installing screw
3.Put duct tape over the screws on the inside of the tire; sometimes it is best to use two layers of tape.
Project includes:
Car Tires Studs X 100(About)
