This is a DIY kit for building FanPico Fan Controller (see github.com/tjko/fanpico/).
Kit includes a PCB with SMT components pre-assembled and thru-hole components that require assembly (soldering).
NOTE! This is NOT a finished product, assembly is required.
There is two board variations currently:
- 0401D - 4 x Fan Outputs and 1 x (Motherboard) Fan Input - see https://www.ebay.com/itm/286029640883
- 0804D - 8 x Fan Outputs and 1 x (Motherboard) Fan Input
Kit contents:
Standard Kit:
- FanPico PCB with SMD components pre-assembled
- Fan Connectors (either straight or right-angle versions)
- Temperature Sensor Connectors (either straight or right-angle versions)
- Power Connector (PC "Floppy" power connector)
- Pin headers for the jumpers and TTL Serial port
- Jumpers for the jumper pin headers
- Reset switch
Deluxe Kit:
- Includes everything in the Standard kit
- Female headers for mounting Pico (or Pico W) with headers soldered on (instead of soldering Pico directly onto the PCB).
- Female header for OLED connector
- Straight and Right Angle pin headers for OLED connector (for using cable to relocate OLED display)
- Raspberry Pi Pico W module
- OLED module (128x64 pixels)
Assembled Kit:
- Assembled PCB (with either straight or right-angle fan connectors)
- 1.5" OLED module (128x128 pixels)
- 2 x Temperature Sensors