11.3mm 90 Degree Tyre Valves allow easy access for inflating and checking tire pressures.

These fit to the rim with a locking nut can will not come loose from the wheel.

Please see in store if you require a different colour

Fitment Instructions

Remove old valve stem & clean the valve body and the valve stem hole that is on the rim of the wheel. Insert new valve onto the rim without damaging the base of the valve stem, Attach the nut on the inside of the rim to the valve body. Set valve stem torque to no more than 4nm. Please note that excessive torque may damage the aluminium valve stem threads

Please note it is not suitable for motorcycles which have tyre pressure sensors it will not work with the TPS. If you are using any aftermarket wheels ie Marvic,Marchesini,OZ Etc then the valve stem hole may be different so PLEASE MAKE SURE TO MEASURE that the diameter of the valve stem hole still matches the 11.3mm Valve

Stems. This Size is Suitable for most Japanese motorcycles from 1980 onwards, with certain exceptions (including but not limited to XV , XVS , GTS , Vmax, Virago, Goldwing etc) 

This is not suitable for Ducati,Triumph,MV Agusta,Aprilia etc, please see in store for 8.3mm Valves