DELIVERY WILL TAKE 7-10 WORKING DAYS FROM PURCHASE
This PTO unit and pump set is to suit the Ford Ranger Pick-Up 2.5 TDCI, 2500cc, 4X2 4X4. Year 2006 to 2011. Suitable for models without Air Conditioning. This Kit is made up of a 12 Volt 60Nm Electromagnetic Clutch and hydraulic pump.
PLEASE NOTE – THE ABOVE IMAGE IS USED FOR LISTING PURPOSES ONLY. THIS PTO AND PUMP KIT MAY BE SLIGHTLY DIFFERENT TO IMAGE SHOWN BUT WILL SUIT VEHICLE STATED IN THE TITLE AND DESCRIPTION. PLEASE BE AWARE SOME KITS MAY REQUIRE ADDITIONAL MACHINING AFTER PURCHASE.
The PTO kit manufacturer is located in Italy, and all PTO kits are designed to fit to left hand drive Vehicles driven in mainland Europe. Please check when ordering one of these PTO kits with your vehicle manufacturer if any differences occur in
DELIVERY WILL TAKE 7-10 WORKING DAYS FROM PURCHASE
This PTO unit and pump set is to suit the Ford Ranger Pick-Up 2.5 TDCI, 2500cc, 4X2 & 4X4. Year 2006 to 2011. Suitable for models without Air Conditioning. This Kit is made up of a 12 Volt 60Nm Electromagnetic Clutch and hydraulic pump.
PLEASE NOTE – THE ABOVE IMAGE IS USED FOR LISTING PURPOSES ONLY. THIS PTO AND PUMP KIT MAY BE SLIGHTLY DIFFERENT TO IMAGE SHOWN BUT WILL SUIT VEHICLE STATED IN THE TITLE AND DESCRIPTION. PLEASE BE AWARE SOME KITS MAY REQUIRE ADDITIONAL MACHINING AFTER PURCHASE.
The PTO kit manufacturer is located in Italy, and all PTO kits are designed to fit to left hand drive Vehicles driven in mainland Europe. Please check when ordering one of these PTO kits with your vehicle manufacturer if any differences occur in the right hand model version of your vehicle. The Manufacture cannot specify individual models for right hand drive vehicles as they are only able to study vehicles with left hand drive.
>Electro Magnetic Clutch
Bearing Housing
Hydraulic Gear pump
Engine Mounting Bracket
Crankshaft Pulley
V Belt
Clutch and pump bolt kit
This kit is suitable for use on all the following applications and any application where you need hydraulic flow and pressure.
Hiab Type Crane Applications
Recovery Vehicle Tilt and Slide Bodies
Skip Equipment
Tipper applications
Winch applications
Hook loaders
Spec Lifts
Any other hydraulic application needing hydraulic flow and pressure.
Not sure what you need contact us on Tel: 01584 87 6033.
Most Kits bolt straight to the engine block. Please see Assembly instruction pdf.
Unless advised an 8.5 CC Gear pump will be sent as standard
All our combinations are based on 800 rpm engine idling speed which of course can be altered according to your application. The faster the engine revs the more flow you will produce.
Once you have selected your pump don’t forget to order all the components you will require such as Hydraulic Tank complete with filtration accessories, Hydraulic Motors, Hydraulic Cylinders and Hydraulic Valves.