The EQ1208 graphic equalizer is a high-fidelity signal processor/preamplifier that that allows you to graphically view and individually control a number of different frequency bands in a stereophonic system.
It is intended for use in a car audio system which includes amplifiers in the signal path after the equalizer, and provides front, rear and subwoofer low level outputs via RCA connectors.
The EQ1208 consists of several audio filters, each centered at a specific frequency in the audio range. It enables you to cut or boost the output level by up to 18 decibels as desired at the following frequencies: 40Hz, 150Hz, 1kHz, 20kHz.
It also features a subwoofer channel with an independent crossover control.
The crossover can be set from 30Hz to 250Hz. Any signal below the frequency setting will be sent to the subwoofer outputs, allowing you to optimize the sound to suit your particular subwoofer setup. Use of the subwoofer channel is optional.
Top Panel Controls
- EQ center frequencies: 60Hz, 150Hz, 400Hz, 1kHz, 3kHz, 6kHz, 15kHz.
- Equalization range: (boost/cut) +/- 12dB.
- Frequency response: 20 Hz – 20kHz.
- Subwoofer crossover frequency: Variable 30-20Hz.
- Signal to noise ratio: 60 dB.
- Equalizer THD: Less than 0.05%.
- Subwoofer channel THD: Less than 0.05%.
- Channel separation: 45 dB.
- Power supply: 10-16V negative ground.
- Output voltage (subwoofer channel only): 1.5V.
- Dimensions: 6.8” W x 4.25” D x 1.1” H.