Get better performance and increased FPS from your blaster by switching from a larger bore barrel to a tight 17/32" brass barrel. Additionally, performance can often be gained by selecting a length that is longer than the original barrel. Do not select more than 12" unless you have made considerable modifications to the blaster (more than just a spring swap or spring spacer).

A set of two 17/32" to 16mm barrel shim adapters are included with every barrel but are not glued on. Glue isn't completely necessary due to the tight fit of the shim adapters but is recommended if you want to guarantee the highest performance possible for the blaster you install it into.

It is also recommended to cover the exposed end of your brass barrel with an attachment, shroud, or cap (like what I provide in my store). Brass barrel walls are very thin and can be dangerous if ran into.

Note that some darts may not be a good fit for such a tight barrel diameter. It is recommended that any dart with a head that is the same size or larger not be used with a 17/32" diameter brass barrel as the chance for jamming is significant. Ideally, short darts should be used such as those from Dart Zone, Adventure Force, or Worker.

INCLUDES:
• 1x Brass Barrel of selected length. All measurements are approximate but are within 1/8" of the selected length.
• 1x set of 16mm shim adapters.

INSTALLATION: Simply install in place of the stock barrel. You may require a shim or adapter depending on the blaster. For more details, check out the listings for those items.

MATERIAL NOTES: This product is printed in PETG material which offers superior thermal resistance and increased durability compared to PLA products. PETG has a higher glass transition temperature of 80°C whereas PLA is 60-65°C. For PLA, this is within range of the temperatures that often occur inside a vehicle during summertime so items made from PLA may end up warping in those situations. The same issue can possibly occur from exposure to direct sunlight if the temperature is high enough. PETG has a much higher glass transition temperature however so you are very unlikely to ever experience issues with it warping in addition to it just being stronger in general. PETG products do come at a higher cost than the same product in PLA because PETG takes longer to print and also requires more time to clean up after printing but the result is a very high-quality product.

DISCLAIMER: All of my products are printed and tested with the utmost attention to detail. Despite this, I am NOT responsible for any damage incurred to you or your blasters through the use of any of these parts by themselves or in combination with others. It is up to you to keep yourself and your blasters in functioning condition. Some prints may have slight imperfections as is common to all 3D printing (especially for PETG). These slight imperfections will not interfere with mechanical function or integrity/strength.

B-STOCK: B-stock items are items that are only defective in appearance and are offered at a discount for this reason. They should function like the normal product unless otherwise specifically noted in the listing.


Powered by ExportYourStore.com