Introduction:
Two OBD cable adapters plus an ELM OBD2 USB Diagnostic Lead plus a Security Gateway Module Bypass to allow additional diagnostic options for Italian cars. These can include ENGINE, ABS, POWER STEERING and CAN ECU's (an additional KKL VAG COM may be required to connect to specific ECUs, [depending on car model]).
Specification:
Blue Adapter Lead (Adapter 5)
Grey Adapter Lead (Adapter 6)
Security Gateway Module Bypass (to bypass security module on Fiat Chrysler Automobiles post 2018 models)
Pin Configurations:
Blue Adapter Lead = Female pin 6 to male pin 3 / Female pin 14 to male pin 11.
Grey Adapter Lead = Female pin 6 to male pin 12 / Female pin 14 to male pin 13.
Modified ELM:
* Please note that this ELM 327 HAS been modified to resolve the connection problems reported
"Please note that almost all ELM 327 interfaces produced in the last few months have problems accesing the CAN network.The problem can be easily fixed by simply removing one resistor from the interface. The procedure is covered in the following topic on the forum: FAULTY ELM 327 INTERFACES DE-MYSTIFIED.
It was also reported that the new OBDLink interfaces have the same problem."
Additional Items Required:
Software (full version)
Other Details:
Cables fully tested on supported model before shipping.
No responsibility can be accepted for any damage caused by the lead.
Some models may require the full version of the software to communicate with some ECUs.