|
|
||||||
|
|
|
|
NOTE: Each AC air compressor comes with about 80ML of Oil. You dont need to add oil additionally.
Fitment:
2003-2006 Acura MDX 3.5L
2005-2007 Honda Odyssey 3.5L
2005-2008 Honda Pilot 3.5L
2006-2008 Honda Ridgeline 3.5L
Interchange Part Number:
38810RCAA01, 38810RDAA01, 38810RDJA0,CO 10736C+97307+98307
Installation Method
Attention Please:
Be sure to clean the air conditioning system before installation, otherwise it will cause compression broken.
1. Remove compressor:
Remove the A/C belt from the A/C compressor pulley. May involve loosening the belt tensioner (if equipped).
2.receiver drier or accumulator, orifice tube or expansion valve.
3.Disconnect the negative battery cable.
4.Remove the bolt that secures refrigerant lines to the A/C compressor. Inspect A/C lines for any contamination such as metal or excessive dirt inside of them. If you find any
contamination the system will need to be cleaned.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before
the evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet.
5.Drain all the oil from the new compressor ,if you compressor has a drain plug you will need to open it up and drain what oil is in there too.
6.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal
parts are lubricated.
7.Install new receiver drier or accumulator and new orifice tube or expansion valve.
8.Evacuate the A/C system for a minimum of one hour.
9.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout
the system.
10.Turn on the A/C system with the engine running and check to see if cold air is now coming out of the air duct.
11.If the A/C system is functioning ,you may find that your electric radiator fan and compressor clutch will be cycling off and on depending on the outside air temperature.
To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table.
Note:
This compressor comes pre-filled with the correct amount of oil. Thus, there is no need to add any additional oil to your system.
Please add refrigerant to 70-80% without filling up.
There may be noise if the refrigerant is added too much.
Item Specifics | |
---|---|
Interchange Part Number | CO 10736C |
Manufacturer Part Number | CG410184LD |
Brand | coolgood18 |
Manufacturer Warranty | 1 Year |
Interchange Part Number1 | 38810RCAA01, 38810RDAA01, 38810RDJA0 |
Pulley Groove Quantity | 6 |
Type | Compressor & Clutch Assembly |
OE/OEM Part Number | CO 10736C |
Pulley Belt Type | Multi-Groove Serpentine |
Country/Region of Manufacture | America |
Universal Fitment | No |
Material | Aluminum |
■ There are always uncertainties during shipping, if your item does not show up over the period we estimate to arrive, please feel free to contact us.
■ Our warehouses are located in California. We will arrange the shipping according to your location and the inventory situation of warehouse.
■ Items are mailed by USPS or Fedex.
■ All items are shipped out within 72 hours after payment is received.
■ We work on weekday and Saturday forenoon, excluding weekend & holidays. Pls note that items purchased on weekends and Bank Holidays are dispatched the next working day.
■ Ship to Ebay shipping address. (Please make sure your Ebay shipping address is correct before finalizing order and submitting payment.
■ We only ship to the shipping address submitted with the payment!) .We will not be responsible for item loss due to wrong or unknown address.
■ After receiving the item, cancel the purchase within 30 days
■ Return policy details:
If you are not satisfied with the item,we can accept return. Refund accepted: If item is broken when it arrives or,if there is any problem within 30 days; a refund is acceptable. Please leave us 5 perfect stars if you are satisfied with our service. If you are disatisfied,contact us first and we will resolve problems as much as we can do for you.
■ We work on weekdays and Saturday forenoon, excluding weekend & holidays.
■ Please feel free to contact us if you have any questions about our items. If your item fails to work or something goes wrong within the warranty period, pls contact us via eBay message first and we will spare no effort to solve the problem for you, till the problem was solved.
■ If you want to returm the item, Please contact us via eBay message first and finish the returning process.
Shop Category |
AC Compressor For 05-07 Honda Odyssey Pilot 2003-2006 Acura MDX CO 10736C
NOTE: Each AC air compressor comes with about 80ML of Oil. You dont need to add oil additionally.
Fitment: 2003-2006 Acura MDX 3.5L 2005-2007 Honda Odyssey 3.5L 2005-2008 Honda Pilot 3.5L 2006-2008 Honda Ridgeline 3.5L
38810RCAA01, 38810RDAA01, 38810RDJA0,CO 10736C+97307+98307
Installation Method Attention Please: Be sure to clean the air conditioning system before installation, otherwise it will cause compression broken. 1. Remove compressor: Remove the A/C belt from the A/C compressor pulley. May involve loosening the belt tensioner (if equipped). 2.receiver drier or accumulator, orifice tube or expansion valve. 3.Disconnect the negative battery cable. 4.Remove the bolt that secures refrigerant lines to the A/C compressor. Inspect A/C lines for any contamination such as metal or excessive dirt inside of them. If you find any contamination the system will need to be cleaned.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before the evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet. 5.Drain all the oil from the new compressor ,if you compressor has a drain plug you will need to open it up and drain what oil is in there too. 6.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated. 7.Install new receiver drier or accumulator and new orifice tube or expansion valve. 8.Evacuate the A/C system for a minimum of one hour. 9.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout the system. 10.Turn on the A/C system with the engine running and check to see if cold air is now coming out of the air duct. 11.If the A/C system is functioning ,you may find that your electric radiator fan and compressor clutch will be cycling off and on depending on the outside air temperature. To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table.
This compressor comes pre-filled with the correct amount of oil. Thus, there is no need to add any additional oil to your system. Please add refrigerant to 70-80% without filling up. There may be noise if the refrigerant is added too much. Payment
Shipping
■ There are always uncertainties during shipping, if your item does not show up over the period we estimate to arrive, please feel free to contact us. Returns
■ After receiving the item, cancel the purchase within 30 days Customer Services
■ We work on weekdays and Saturday forenoon, excluding weekend & holidays. Feedback
All rights reserved. |