Note: Our warehouse has two version of these headlights, but they are the same factory and function, we will ship them randomly, thanks for your understanding.
Fitment:
For 2001-2011 Ford Ranger
Vehicle Compatibility Reference Number: 6L5Z13008BA, 6L5Z13008AA, FO2503173, FO2502173, 3L5Z13008CA, F87Z13008FB, 3L5Z13008BA, F87Z13008EB
Item Description:
Completely sealed: Prevents moisture from being trapped inside the housing
One-way vent: Drives out moisture and avoids lens misting
Multi-surface reflectors: Increase light output & distance
PC lens: Impact resistance for an enhanced driving experience in any environment.
Specification :
Condition: 100% Brand New and High Quality
Made of materials that meet or exceed OEM requirements
Color: Black Housing + Clear Lens
Turn Signal Bulbs Type: 3457A (No included)
Low Beam / High Beam Bulbs Type: HB5 / 9007 (No included)
Package Included:
Pair LH (Driver Side)+RH(Passenger Side)Headlights+Corner Lights
Tips:
(How to install):
1.Undo the screws, clips, or retainer springs that hold the headlight in place.
2.Disconnect the wiring from the assembly.
3.Detach the headlight from the vehicle to replace it with a new one.
4.Fit in the new headlight assembly.
5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.
6.Reconnect the wiring that was unplugged from the assembly.
7.Put back the grille and other components that you removed. Seal them back into place.
8.Test the new assembly.
(How to adjust your headlight):
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.
1. Find the adjustment screws. Firstly, locate the adjustment screws on your vehicle.
2. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3. Adjust the vertical field. The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.
4. Adjust the horizontal field. The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5. Test your results.