Ronseal Diamond Hard Floor Varnish

Ronseal Diamond Hard Floor Varnish is an advanced polyurethane formulation that provides an exceptionally hard wearing and long lasting floor finish. Its advanced formula is designed to give unbeatable protection from scratches, scuffs, knocks and household chemicals. Ronseal Diamond Hard Floor Varnish is fast drying, low odour and will leave your floor with a beautifully smooth, rich and long lasting protection. It can be used on bare, new and previously varnished floors. Preparation and Application: Before beginning, make sure the room is warmer than 10°C and well ventilated. If there are any holes or imperfections in the wood then they can be filled with Ronseal Multipurpose Wood Filler. If the floor is unvarnished or has flaking varnish then sand with a 120 grit abrasive, taking the surface back to bare wood. Remove all trace of dust and wipe down with White Spirit. Previously varnished floors can be sanded with 120 grit abrasive to give a key. Remove all dust and wipe with White Spirit. Stir the varnish thoroughly and do a test patch to ascertain the results. Apply with a 4” brush and allow the varnish to dry for 2 hours before the second coat is applied. Before the final coat key the surface with 240 grit abrasive and wipe the floor with a damp cloth. The floor can be walked on after 2 hours but will need to be left for 24 hours before furniture is brought back in. The varnish will be fully cured after 72 hours. After 72 hours the floor can be cleaned by vacuuming or sweeping. Dirt or grit can be cleaned up with a damp microfibre cloth. If an area of the floor becomes damaged it can be repaired with three further coats of varnish. Available colours 2.5 litre satin: Antique Pine, Light Oak, Medium Oak, Dark Oak, Rich Mahogany, Walnut, White Ash Available colours 5 litre: Clear satin, Clear Gloss SPECIFICATIONS: No. of coats: 3 Coverage: up to 18m2 Drying time: Touch dry in 30 minutes, re-coat after 2 hours Clean up: Warm soapy water SAFETY DATA SHEET DOWNLOAD