Attention: It is normal to find wrinkles or bubbles on the stickers upon receipt, and it will not affect installation and use. Because our stickers are made of vinyl material, they become soft when heated. Heating them during installation will remove wrinkles and achieve the best installation effect.
Installation steps:
1. Clean the car body and remove any oil, water, or dust from the surface.
2. After determining the installation position, fix the sticker on the car with tape to prevent any movement during installation.
3. Use a hot air gun or hair dryer to heat the sticker and make it soft.
4. Peel off the protective film of the adhesive while using a plastic scraper or bank card to scrape the sticker flat, eliminating bubbles and wrinkles.