Thanks for choosing RC Engine Bearings USA (cbr10006zu2) USA Ebay Seller 23 years.
Visit My eBay Store: RC Engine Bearings |
If you don't see your Engine listed email me I have sets for most engines.
PLEASE CHECK FITMENT GUIDE BELOW
We only sell Quality Premium Grade ABEC3 or better upgrade Hi Speed Bearings
and for only a couple dollars more than the common unknown spec
or abec1 rated low grade soft metals general use Bearings,
our Premium Bearings are all correct C3 Clearance
for heat in Model Nitro/Gas Engines, we only sell True Sealed Bearings,
Not the old leaky shield type.
We get our Bearings from proven reliable US Bearing Suppliers.
We supply Clubs and engine Rebuilders.
I'm VeriSign and PayPal Verified . I've been on Ebay 20+ years and have 100% Feedback + Money Back Guarantee.
We have the 5 STAR Rating on Seller.com and EBAY Top Rated Plus
INTERNATIONAL SHIPPING Discontinued until problems with pricing and shipping are resolved.
(Included Printed BEARING Installation guide, Tips and 4 Stroke Timing instructions)
I've rebuilt over 800 Model Engines if you need Help just email me.
Fitment guide for these Bearings
((( 6902 ))) ID 15mm x OD 28mm x Width 7mm Dimensions
((( 698 ))) ID 8mm x OD 19mm x Width 6mm Dimensions
GMS 40 ABC 40
GMS 47 ABC 47
ROSSI F3D PYLON 40
ROSSI MARINE 45
SAITO FA-62A 62
TOWER HOBBIES 46
Engine BEARING Care and storage info.
Why pay $30 or 40 dollars for low grade or no grade factory bulk bearings that don't last long
compared to Premium Industrial Grade ABEC3/C3 High Speed Bearings,
get some spares if you leave fuel in your engine they will need replaced
after they gum up or turn into a ball of rust, you can save buying a new engine
by replacing gummy or rusted, stuck, rough or loose bearings
before they come apart and damage the piston, head and sleeve.
Save $$$ New Premium ABEC3/C3 Bearings make a big difference in engine performance.
I always remove the fuel line and idle the engine dry, then put in marvel mystery oil
or after run oil and spin it over, for long tern add liberal amounts of
After Run Oil and cap off carb and exhaust, if the engine sets for a long time
Not properly oiled it may appear to turn smoothly but some of the time the bearings aren't even turning,
then when started the crank spins in the inner bearing race, not good.